3.Enter the following command:
#cd /opt/hptc/config/sbin
4.Enter the following command:
#./discover --enclosurebased --single --ic=AdminNet
5.Enter the following responses as indicated. For more information, see Section 3.6.3 in the HP XC System Software Installation Guide. For example:
Enter the MAC address of the OA for the enclosure in the format xx:xx:xx:xx:xx:xx : oa_mac_address
Enter the common user name for all console port management devices: root
Enter password: Test1234
Please
Upon completion, the OA has the address 172.31.32.1. If you need to access the OA, run a browser (e.g. Firefox) on the head node.
5.6Running the cluster_config Command
To run the cluster_config command, follow these steps:
1.Enter the following command:
#cd /opt/hptc/config/sbin
2.Enter the following command:
#./cluster_config
Enter the following responses as indicated. For more information, see Sections 3.8 through
3.11in the HP XC System Software Installation Guide. For example:
HP recommends that you back up the database before proceeding. Do you want to back up the database? (yes/no) [y]: Enter
[L]ist Nodes, [M]odify Nodes, [A]nalyze, [H]elp, [P]roceed, [Q]uit:
P
NOTE: You might receive an error as follows:
Warning: Unable to get host by address for head node external network xxx.xxx.xxx.xxx
Warning: This could indicate a problem with DNS lookup Warning: Using null name with name of xxx.xxx.xxx.xxx [L]ist Node [M]odify nodes [A]analyz [H]elp [P]:
You can ignore this error because the system isn't connected to the external network.
Do you want to apply your changes to the cluster configuration? [y/n]: y
[S]ervices Config, [P]roceed, [Q]uit: P
Do you want to apply your changes to the cluster configuration? [y/n]: y
Do you want to apply your changes to the service configuration? [y/n]: y
5.6 Running the cluster_config Command 31