HP Workgroup System AWSXCIG-1A manual Associating the Enclosure DVD to the Head Node

Page 25

If you have not received the license key file, contact your HP representative.

4.4 Associating the Enclosure DVD to the Head Node

To associate the enclosure DVD to the head node (Bay 1), follow these steps:

1.From the OA left navigation frame, go to Enclosure Settings. (Figure 4-1)

2.Go to DVD drive.

3.Check 1.

4.Choose DVD.

5.Connect to the enclosure DVD.

Figure 4-1 DVD Drive

4.4 Associating the Enclosure DVD to the Head Node 25

Image 25

Contents HP Workgroup System and XC Software Installation Guide Copyright 2008 Hewlett-Packard Development Company, L.P Table of Contents Cabling IP Addresses HP Workgroup System Specifications Thermal StabilizationEnclosure Bay Numbering Example Rear View List of FiguresRemoving the Box OA IP AddressList of Tables Modify Database List of ExamplesPage Intended Audience About This DocumentDocument Organization Typographic ConventionsHP Encourages Your Comments Documentation Updates and Release NotesUser input HP Workgroup System Views HP Workgroup System Overview3shows an example rear view of the HP Workgroup System Hardware Prerequisites Hardware Preinstallation ChecklistFirmware Requirements HP c-Class BladeSystem Enclosure Components and Switches Can cause problemsUnpack the Enclosure Hardware SetupGently roll the unit down the ramp. Callout 1, Figure Removing the Ramp and Front CushionPlug the unit into a power source Installing and Starting Up the HardwareInterconnect Switch Save user information Setting Boot OrderEnabling Telnet Access Installing and Starting Up the Hardware Page Software Prerequisites Software Preinstallation ChecklistCopying the XC.lic File to Your Laptop Downloading XC Software PatchesCheck Choose DVD Connect to the enclosure DVD Associating the Enclosure DVD to the Head NodePage Booting the DVD XC Software InstallationBoot linux ks=hdscd0/ks.cfg Boot linux ks=hdscd0/ks.cfg pci=nommconf# cd /opt/hptc/config/sbin Running the clusterprep Command# ./clusterprep --enclosurebased # mkdir /home/patches Installing Patches from Your Laptop# cp /media/iLO2FOLDER/* /home/patches # cd /home/patchesPutting the License Key File in the Correct Location Running the discover Command# cp /media/iLO2-FOLDER/* /opt/hptc/etc/license/XC.lic # ./discover --enclosurebased --single --ic=AdminNet Running the clusterconfig Command# ./clusterconfig Example 5-2 clusterconfig Command Output Ok, Respecify Interfaces O Configuring the Snmp Trap Running the startsys CommandVerifying LSF-HPC with Slurm LSF Post-Configuration TasksRunning the OVP to Verify Software and Hardware Components Follow along with the OVP command outputVerify the dynamic resource information Nagios Web Interface Nrg CommandCreating a Baseline Copy of the Database Creating a Baseline Report of the System ConfigurationStop bits Flow control Setting Up VlanConfirm saving to Flash y/n y Unable to Manually Set IP Addresses for the iLOs TroubleshootingChanging External IP Addresses For example Copy the fileLost Connection to the iLO # sysstart imageandrebootRemoving a Bad Golden Image # siimage baseimageLost Terminal Window When in the IRC Page # scontrol reconfig Additional Software Setup Information# spconfig Page HP Workgroup System Specifications Additional Hardware Setup InformationTable B-2 Thermal Stabilization Specification Cabling IP Addresses on a Corporate NetworkIP Addresses Extend the Insight Display PanelFigure C-3 OA IP Address Locate the section of the file that is similar to this Configure sendmailConfigure sendmail Network Base image GlossaryItrc NAT SMP LSF IndexXC installation, 27 XC license, 24 XC patches