![](/images/new-backgrounds/1212950/212950109x1.webp)
NOTE: If this method is not successful, try using the wireless network setup using the USB cable method.
Connect the product to a wireless network using a USB cable
If your wireless router does not support
1.Insert the software CD into the computer CD tray.
2.Follow the
CAUTION: Do not connect the USB cable until the installation program prompts you.
3.When the installation is complete, print a configuration page to make sure that the product has a SSID name.
4.When installation is complete, disconnect the USB cable.
Install the software for a wireless product currently on the network
If the product already has an IP address on a wireless network and you want to install product software on a computer, complete the following steps.
1.From the product control panel, print a configuration page to obtain the product IP address.
2.Install the software from the CD.
3.Follow the
4.When prompted, select the Connect through a wireless network option, and then click the Next button.
5.From the list of available printers, select the printer that has the correct IP address.
Disconnect from the wireless network
If you want to disconnect the product from a wireless network, you can turn off the wireless unit in the product.
1.At the product control panel, press and release the Wireless button.
2.To confirm that the wireless unit is turned off, print a configuration page and then verify that the status is specified as disabled on the configuration page.
ENWW | Connect to a network by using the software |