HP 9250C manual Ping Test, Dest Type, Dest IP, Packet Size, Count, Show Results

Menu item

Sub-menu item

Sub-menu item

Values and Description

Ping Test

This test is used to check network communications.

This test sends link-level packets to a remote network

host, then waits for an appropriate response. To run a

ping test, set the following items:

Dest Type

Specify whether the target device is an IPv4 or IPv6

node.

Dest IP

IPV4: Type the IPv4 address.

IPV6: Type the IPv6 address.

Packet Size

Specify the size of each packet, in bytes, to be sent to

the remote host. The minimum is 64 (default) and the

maximum is 2048.

Timeout

Specify the length of time, in seconds, to wait for a

response from the remote host. The default is 1 and

the maximum is 100.

Count

Specify the number of ping test packets to send for this

test. Select a value from 1 to 100. To configure the test

to run continuously, select 0.

Show Results

If the ping test was not set for continuous operation,

you can choose to display the test results. Select Yes

to show results. If you select No (default), results are

not shown.

Execute

Specify whether to initiate the ping test. Select Yes to

initiate the test, or No to not run the test.

ENWW

Initial Setup menu 25