BENDIX BW2212 manual IR Camera Window Heater Replacement, Bezel Heater Assembly and Retaining Plug

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

IR CAMERA WINDOW HEATER REPLACEMENT

1.Unlock the IR camera by turning the two IR camera aiming adjusters and the IR camera standoff 1/4 turn counterclockwise.

2.Remove the IR camera from the IR camera bracket to gain easier access to the connectors.

3.Disconnect the 6-pin IR camera connector and the 2-pin window heater connector of the IR camera harness from the IR camera.

4.Lay the IR camera face-up for easier access to the bezel retaining plug. Refer to Figure 27.

Bezel Heater

Assembly

IR Camera

Window

		Black side
	IR Camera
IR Camera	Window Seal		Bezel Retaining Plug

FIGURE 27 - BEZEL HEATER ASSEMBLY AND RETAINING PLUG

5.Remove the bezel retaining plug.

6.Turn the bezel heater assembly 1/4 turn counterclockwise, until it separates from the IR camera. Use care to prevent the window from falling and breaking.

7.Turn the new bezel heater assembly 1/4 turn clockwise onto the IR camera. Note: Ensure the window has not moved or it will be damaged.

8.Lock the new heater in position with the bezel retaining plug.

9.Plug the 2-pin connector of the IR camera harness into the window heater. Refer to Figure 24.

10.Plug the 6-pin connector of the IR camera harness into the IR camera connection. Refer to Figure 24.

11.Position the IR camera onto the factory-installed aiming assemblies.

12.Rotate the pivot locks on the end of the aiming assemblies 1/4 turn clockwise, using the aiming adjuster tool. This will lock the IR camera in position.

13.Aim and adjust the IR camera. Refer to Aiming the IR Camera on pages 21 and 22.

15