BENDIX BW2212 manual Heat Shrinkable Shroud Assembly

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

wrench to approximately 15 to 20 in-lbs. or until the o-ring is slightly flattened.

16.Route the IR camera harness to the “A” pillar of the cab.

17.Connect the 8-pin connector of the IR camera harness to the display harness.

Heat Shrinkable Shroud

O-Ring

Externally

Threaded Nut

.

in

3

(Approximately)

FIGURE 31 - HEAT SHRINKABLE SHROUD ASSEMBLY

18.Pull the IR camera harness through the opening between the IR camera bracket and mounting bracket.

19.Plug the 2-pin connector of the IR camera harness into the window heater. Refer to Figure 32.

20.Plug the 6-pin connector of the IR camera harness into the IR camera connection. Refer to Figure 32.

Cable Tie

21.Loosely install the harness tie-wrap around the harness.

22.Position the IR camera onto the factory-installed aiming assemblies. Refer to Figure 33.

23.Rotate the pivot locks on the ends of the aiming assemblies 1/4 turn clockwise using the included aiming adjuster tool. This will lock the IR camera in position.

FIGURE 33 - FULLY ASSEMBLED CAMERA

24.Securely tighten the harness cable tie.

25.Ensure that the harness reaches the “A” pillar without trouble. Once the shroud assembly is heat-shrunk, the harness cannot be moved or adjusted.

26.After the IR camera harness is properly secured and routed, heat-shrink the shroud assembly from the outside of the vehicle, using a heat gun.

WARNING: Do not touch the shroud assembly after it has been heat-shrunk. It will be hot and may cause burns.

IMPORTANT: Be careful not to melt the wiring or o-ring during the heat shrinking process.

6-pin connector

2-pin connector

FIGURE 32 - CONNECTING THE CAMERA HARNESSES

19