BENDIX BW2212 manual Vertical Aiming and Adjusting, Vertical Aiming Adjuster

Page 22

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

VERTICAL AIMING AND ADJUSTING

The virtual image should be aligned vertically so that the horizon appears in the lower one-half to one-third of the combiner. Keeping the image at this adjustment should provide a view of the road when the vehicle is driven up and down hills.

The vertical aiming adjusters can accommodate approximately ±4 degrees of movement. If the IR camera needs more than 4 degrees of vertical movement the IR camera bracket will need to be adjusted. Before changing the vertical aiming adjuster, make sure the 5/16 bolts of the IR camera bracket are tightened to 90-100 in.-lbs.

1.Using Figures 39 - 42 and a T15 Torx wrench, adjust the angle of the IR camera as needed.

NOTE: Two turns of the vertical adjuster is equal to one degree of IR camera movement.

NOTE: It is recommended that the IR camera adjusters be aimed to view approximately 200 ft (61m) in front of the vehicle. Any thermal objects closer than 200 feet will already be illuminated by the low beam headlamps.

Vertical

Aiming

Adjuster

5/16 Bolts Tighten to 90-100 in-lbs.

FIGURE 39 - VERTICAL AIMING ADJUSTER

NOTE: Do not tamper with or adjust any factory-installed screws while aiming the camera. Only turn the vertical aiming adjuster.

Combiner Image

Center of

 

 

Combiner

Horizon

 

Line 200 ft. from Vehicle

 

Driver’s View

 

FIGURE 40 - IR CAMERA AIMED TOO HIGH

Horizon

Combiner Image

Center of

 

 

 

Combiner

 

 

200 ft. line

 

Line 200 ft. from Vehicle

 

 

Driver’s View

 

FIGURE 41 - IR CAMERA AIMED TOO LOW

 

Combiner Image

Center of

 

 

Horizon

 

Combiner

 

 

200 ft. line

 

Line 200 ft. from Vehicle

 

 

Driver’s View

 

FIGURE 42 - IR CAMERA AIMED CORRECTLY

22

Image 22
Contents SD-19-5160 Table of Contents Introduction Safe Maintenance PracticesComponents IR Camera Bracket KIT Piece no Includes CB Style Mounting KIT Piece noFriction Hinge Mounting KIT Piece no CB Style Dashboard CB Style OverheadHarness KIT Piece no Display Harness CB MountsRED Aiming Adjuster Tool IR CAMERA/ Display CombinationReplacement Kits Servicing the Xvision System Power and Ground Power InputsElectrical System Operating Input VoltageIR Camera Bracket Replacement Attach the IR camera harnessMaintaining IR CameraAttach the IR camera to the IR camera bracket Replacing IR CameraReplacing the Aiming Adjusters Aiming Adjuster Replacement KIT ComponentsIR Camera Window ReplacingIR Camera Window Heater Replacement Bezel Heater Assembly and Retaining PlugReplacing the Combiner Mirror DisplayMaintaining the Combiner Mirror Maintaining the Fold MirrorDisplay Bracket Replacement CB Style Mount Dashboard Base Plate 8-32 MountingCB Style Mount Dashboard and/or Overhead Harness ReplacementDisplay Replacement Friction Hinge Mount VisorHeat Shrinkable Shroud Assembly Vehicle Harness Display HarnessJumper Harness Horizontal Aiming and Adjusting Aiming the IR CameraVertical Aiming and Adjusting Vertical Aiming AdjusterPage Troubleshooting Figures 8 & 9 onSituation Possible Solutions Page