BENDIX BW2212 manual Display Harness, Vehicle Harness, Jumper Harness

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

27.Re-install the headliner and the “A” pillar cover.

28.Turn on the system to verify that it is operating correctly.

29.Aim and adjust the IR camera. Refer to Aiming the IR Camera on pages 20 and 21.

Display Harness

1.Unscrew and disconnect the 25-pin connector of the display harness.

2.Remove the trim pieces covering the harness.

3.Disconnect the display harness from the 8-pin IR camera harness connector and the 3-pin vehicle harness connector.

4.Remove any fasteners securing the display harness.

5.Connect the new display harness as follows:

•the 3-pin connector to the vehicle harness.

•the 8-pin connector to the IR camera harness.

•the 25-pin connector to the display.

6.Turn on the system to verify that it is operating correctly.

7.Replace the “A” pillar cover.

8.Secure the new display harness every 3 in. with cable ties.

Vehicle Harness

WARNING: Improper installation of the vehicle harness can cause damage to your vehicle’s wiring and/or to the Bendix® XVision® Night Vision System. It is the responsibility of the installer to review wiring and service information for the vehicle and to identify proper locations for connecting the vehicle harness to the power. Many modern vehicles have additional, built-in fused accessory power breakouts and these breakouts should be used if at all possible.

1.Remove the trim pieces covering the harness.

2.Disconnect the vehicle harness from the display harness.

3.Remove the red wire (A-contact) from the ignition bus.

4.Remove the blue wire (C-contact) that is butt-spliced between the headlamp and the headlamp switch.

5.Remove the black wire (ground) from the ground bus.

6.Remove any fasteners securing the vehicle harness.

7.Remove the old vehicle harness.

8.Strip the three ends of the new vehicle harness.

9.Connect the red wire (A-contact) of the new vehicle harness to the ignition bus with a 3 A slow open fuse.

TABLE 6 - VEHICLE HARNESS WIRING

	Vehicle Harness		Fused	Color
Connector 3 Contacts
A		Vehicle ignition	3 A slow open fuse	RED
		+12 Volts	(max.)
B		Vehicle ground		BLACK
C		Headlamp active	1 A fast open fuse	BLUE
			(max.)

	3 AMP slow
	open fuse
A	Red	Ignition
		Switch
	Wire		Headlamp
	Ignition			Battery
	bus
C	Blue
	Wire		Headlamp
			Switch
			1 AMP fast
	Black		open fuse
B		Ground	Butt
	Wire	Bus	Splice

FIGURE 34 - XVISION SYSTEM ELECTRICAL POWER SCHEMATIC

10.Butt splice the blue wire (C-contact) of the new vehicle harness between the headlamp and the headlamp switch with a 1 A fast open fuse.

11.Connect the black wire to the ground bus.

12.Route the new vehicle harness to the display harness and connect them.

13.Turn the system on to verify that it is operating correctly.

14.Secure the new vehicle harness every 6-12 in. with cable ties.

15.Replace the “A” pillar cover.

Jumper Harness

1.Remove any fasteners securing the jumper harness.

2.Disconnect the jumper harness from the IR camera harness and the display harness.

3.Connect the replacement jumper harness to the IR camera harness and the display harness.

4.Turn the system on to verify that it is operating correctly.

5.Secure the new jumper harness every 6-12 in. with cable ties.

20