BENDIX BW2212 manual Troubleshooting, Figures 8 & 9 on

TROUBLESHOOTING

Troubleshooting Your Bendix® XVision® Night Vision System

Situation		Possible Solutions
No image on the display. Bendix logo does not	Check that the combiner is open to an angle that allows you to
appear during power-up, combiner and fold	see the image.
mirror are open.
	Make sure the vehicle accessory power, headlights, and the
	XVision system are all on.
	Check that the display intensity is set at an appropriate level to
	view the image.
	Check that the 25-pin connector of the display harness is com-
	pletely plugged into the display and fastened.
	Check the 25-pin display harness connections, reference
	XVision system schematic, figure 43 on page 23 @ #
	25-pin	Description	Voltage
	2	Vehicle Ground	ground
	11	Headlamp	+ 12 Volts
	13	Ignition	+ 12 Volts
Incorrect voltage value, ignition, headlamp,	Check that the 3 A slow open fuse connecting the red wire of
ground, at 25-pin connector.	the vehicle harness to the 12V battery is intact. Check that
	there is 12 Volts at this location, using a multimeter.
	Check that the 1 A fast open fuse connecting the blue wire
	of the vehicle harness to the head lamp circuit is intact. With
	headlamps on, check that there is 12 Volts at this location, us-
	ing a multimeter.
	Check the ground connection of the vehicle harness.
	Check the 3-pin vehicle harness connections, reference
	XVision system schematic, figure 43, on page 23 @ !
	3-Pin	Description	Voltage
	A	Ignition	+ 12 Volts
	B	Vehicle Ground	ground
	C	Headlamp	+ 12 Volts
Bendix logo remains on the display after 2	Check that the video in/out switch is set to “out.” Reference
minutes.	figure 13 on page 7.
	Check that the 6-pin camera harness connector is plugged
	completely into the IR camera, reference figure 21 on page 10.
	Check that the terminals are seated and the wiring secure.
	Check the 6-pin IR camera harness connections (2 pins not
	used), reference XVision system schematic, figure 43 on
	page 23 @ (
	6-Pin	Description	Voltage
	A	IR camera power	+ 12 Volts
	B	IR camera ground	ground
	Check to see if the IR camera harness 8-pin connector is
	plugged into the display harness 8-pin connector. Reference
	figures 8 & 9 on page 5.

24