Friction Hinge Mounting KIT Piece no

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

Mounting Brackets

CB Style (Dashboard)

CB Style (Overhead)

FIGURE 5 - CB MOUNTING BRACKETS

Knob kit (service piece no. 5010247) – The knob kit includes four 1/4 in. flat washers and two 1/4-20 threaded knobs, which are installed onto both sides of the display when it is mounted in the CB style.

FRICTION HINGE MOUNTING KIT (PIECE NO. 5010082)

Friction hinge mounting allows the driver to use the sun visor during the day and the Bendix® XVision® Night Vision system at night. The display pivots on a pair of friction hinges, similar to a vehicle sun visor. The hinges allow the display to be flipped out of the way of the visor and latched into either position by use of a magnet and striker plates.

The friction hinge mounting kit includes the following items.

Hinge Supports – Two hinge supports secure the display to the vehicle headliner when the friction hinge mount is used. The hinge supports are fastened to the headliner with four #10 Plastite® pan head screws and to the display with two M2.5 threadroll pan head screws.

Magnet Kit (piece no. 5010524) – The magnet kit includes a magnet, striker plates, spring, and hardware. The magnet and spring are attached to the display, and one (1) striker plate is fastened to the vehicle headliner. The other striker plates (2) sandwich the sun visor.

Knob Kit Compo- nents

FIGURE 6 - KNOB KIT COMPONENTS

Plastite® screws – The CB style mounting kit includes four #10 Plastite® screws, each 1/2 in. long. Depending on the chosen CB mount, the screws are used to attach the mounting brackets to either the headliner or dashboard of the vehicle.

Hinge Supports	#10 Plastite Pan Head
Hinge Supports	Screws (Qty. 4)
	Screws (Qty. 4)	M2.5 Threadroll
		M2.5 Threadroll
		Pan Head Screw

Magnet Kit

M2.5 ThreadrollComponents

Pan Head Screw

FIGURE 7 - FRICTION HINGE MOUNTING KIT COMPONENTS

Screw and Shim Kit (piece no. 5010249) – The screw and shim kit includes twelve #10 Plastite® pan head screws and twelve spacer blocks. The screws are used to fasten the friction hinge supports to the vehicle headliner and are supplied in three different lengths. The spacer blocks can be used to level the friction hinge supports, if necessary. Based on the number of spacers needed to level out the mount, use either the 1/2 in., 3/4 in., or 1 in. long screws.