Raypak 240692 manual Indicator Lights

Page 18

STAGES

1

2

3

4

5

6

7

8

INDICATOR LIGHTS

STAGE INDICATORS

The pump driver and each of the output stages' drivers has its own LED indicator. Each of these LEDs is lit whenever the corresponding output relay is energized.

PUMP

CALL FOR HEAT

PUMP INDICATOR

The Pump Indicator is illuminated whenever the pump circuit and pump relay are ener- gized.

CALLFOR HEAT INDICATOR

The Call For Heat Indicator is illuminated whenever a call for heat signal is present. In most applications the thermostat connections on the control board (pg. 13) will be jumpered, which will generate a continuous call for heat signal. The thermostat leads may also be connected to a building management system which will produce the call for heat signal as required.

CONTROL ON

CONTROLON INDICATOR

The Control On Indicator illuminates if all settings and system conditions are such that the control can function properly, and outdoor temperature cutoff temperature setting is less than or equal to the outdoor temperature.

SETTING

SETTING ERROR INDICATOR

ERROR

 

The Setting Error Indicator is illuminated if there is a potentiometer, switch setting or jumper

 

placement error. Refer toTroubleshooting Guide "Setting Error LED Is On".

SENSOR

SENSOR ERROR INDICATOR

ERROR

 

The Sensor Error Indicator is illuminated if either temperature sensor is out of range.

 

Steady on represents outdoor sensor failure, blinking represents water temperature sensor

 

error. See "Sensor Error LED On" in the Troubleshooting Guide (pg. 29).

18

Image 18
Contents Electronic Boiler Sequencer & Outdoor Reset Controller Installation and Operating Instructions Series Electronic Boiler ControlTable of Contents Important Safety Instructions BasicsOptional Configurations IntroductionConcept of Operation Control Features Standard Indicator LightsElectrical Installation Installation and MountingMechanical Installation Install Conduit AS AppropriateWiring Power Source to Controller CheckyourpowersourceAIR Temperature Sensor Outdoor AIR Temperature SensorWater Temperature Sensor Installation Hydronic InstallationsTypical Water Sensor Domestic HOT Water Installations Domestic HOT Water Application Setup ProcedurePool Heating Installations Field Wiring Single-Stage On/Off BoilersInstallation Verification Procedure Power TestControl Familiarization Sequence of Operation Manual OverrideSeries Electronic Boiler Control Module Indicator Lights Reset Ratio Control FunctionsReset Ratio Chart Pump TURN-OFF DelayControl Band Stage TURN-ON DelayOutdoor Cutoff Temperature Outdoor Cutoff DeadbandMaximum Water Temperature SET PointCircuit Board Interior Jumper & Switches AutoManual LEAD-LAG SlaveDHW Output OverrideOptional Controls Night Setback OptionDigital Display Option Replacement Parts List Call OUT DescriptionSystem START-UP Settings System Setting Entered on DateInterior Jumper & Switch Settings Troubleshooting Guide OFFLimited Warranty Litho in U.S.A