Raypak 055B Millivolt System, Lighting Instructions, To Turn OFF GAS to Appliance

Page 4

CAUTION: Propane gas is heavier than air and will settle on the ground. Since propane can accumulate in confined areas, extra care should be exercised when lighting propane heaters.

LIGHTING INSTRUCTIONS AND SHUT-OFF PROCEDURES

MANUALLY LIGHTED PILOTS

( MILLIVOLT SYSTEM)

A.This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS: *Do not try to light any appliance.

*Do not touch any electric switch; do not use any phone in your building.

*Immediately call your gas supplier from a neigh- bor's phone. Follow the gas supplier's instruc- tions.

*If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and to re- place any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Set the thermostat on the lowest setting.

3.Turn On/Off switch to the "Off" position.

4.Remove heater door panel.

5.Push in gas control knob slightly and turn clock-

wise to "Off".

NOTE: Knob cannot be turned from "Pilot" to "Off" unless knob is pushed in slightly. Do not force.

ROBERTSHAW PILOT

HONEYWELL PILOT

6.Wait 5 minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step .

7.Locate pilot mounted on the left side of the burner drawer. For burner drawer location, see location of control section, page 18.

Gas control knobs shown in "Off" position

HONEYWELL

ROBERTSHAW

GAS VALVE

GAS VALVE

MILLIVOLT

MILLIVOLT

Fig. #8081.0

Fig. # 8199

Fig. #8084.0Fig. #8083.0

8. Turn knob on gas control counter-clockwise to "Pilot".

9.Push in control knob all the way and hold in. Immediately place flame to pilot to light. Continue to hold control knob in for about 1 minute after the pilot is lighted, release knob and it will pop back up. Pilot should remain lighted. If it goes out, repeat steps 5 through 9. *If knob does not pop up when released, stop and immediately call your service technician or gas supplier.

*If the pilot does not stay lit after several tries, turn the gas control knob to "Off" and call your

service technician or gas supplier.

10.Stand to the side of the heater and turn the gas

control knob counter clockwise to

 

"On".

 

11. Replace heater door panel.

 

 

 

 

12.Turn On/Off switch to the "On" position.

13.Set thermostat to the desired setting.

 

 

TO TURN OFF GAS TO APPLIANCE

 

 

 

 

 

 

1.

Set the thermostat to the lowest setting.

4.

Push the gas

control knob slightly and turn

2.

Turn On/Off switch to the "Off" position.

 

clockwise to

 

"Off". Do not force.

3.

Remove heater door panel.

5.

Replace heater

panel.

3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Versa What to do if YOU Smell GASContents For Your Safety Read Before Operating START-UP ProceduresBefore START-UP Burners WaterLighting Instructions Millivolt SystemTo Turn OFF GAS to Appliance Electronic Ignition Systems Operating InstructionsMaintenance Care Procedures Water Pressure SwitchAfter START-UP Visual InspectionBasic Tips if Heater will not Fire Pool & SPA Water ChemistryCold Weather Operation Winterizing the SPA HeaterInstallation Instructions General SpecificationReceiving Equipment ALL Heaters Outdoor HeatersVenting Connections Indoor HeatersStep Vent Piping GAS Supply Connections ModelGAS Pressure Regulator Robertshaw MVPlumbing for Water Connections Location Flow RatesCompanion Flange Connections Automatic Chlorinators and Chemical FeedersAuxiliary Bypass Valve Adjustment Pressure Relief Valve InstallationElectrical Wiring Millivolt System Electronic Intermittent Ignition Device System IIDWiring Diagram KEY Fig. #9240Wiring Diagram Millivolt Units With Mechanical Thermostat Wiring Diagram Millivolt Units With Solid State ThermostatWiring Diagram 152178 Model 055 IID CONTROLS/ADJUSTMENTS/REPLACEMENTS Temperature ControlsPressure Switch Servicing InstructionsPressure Switch Adjustment Flame ROLL-OUT Safety Switch High LimitsTWO Speed Pumps High Limit RemovalPilot Removal and Cleaning Burner Drawer RemovalGAS Valve Removal Main Burner and Orifice RemovalDesooting Procedure Unitherm Governor U.G. ReplacementCombustion Chamber Removal Control Immersion Well ReplaceTrouble Shooting Guide Liming Bypassing too much water Electrical Solid State Thermostat Millivolt Measured and Estimated Resistance Match Within 20 PercentElectrical Electronic Ignition IID Troubleshooting Honeywell S8600High Voltage Electrical Solid State Thermostat IID Voltage Between 21.5-28.5Replacement Parts List RAYPAK, INC Agoura Road Westlake VILLAGE, CAIID 13-P 14-P 15-PPage Page Warranty Conditions

055B specifications

The Raypak 055B is a high-performance pool and spa heater recognized for its efficiency, reliability, and advanced technologies tailored to meet the needs of consumers. Its compact design and powerful heating capabilities ensure that users enjoy warm water conditions regardless of the outdoor temperature.

One of the main features of the Raypak 055B is its exceptional heating output. With a power rating that can efficiently heat both pools and spas, this model is designed for performance. The heater's efficient heat exchanger is constructed from copper that enhances the transfer of heat, allowing for rapid heating while optimizing energy use. This results in lower utility bills and a smaller environmental footprint.

The Raypak 055B incorporates innovative technology that enhances user experience. It features a digital display that allows for precise temperature control and easy adjustments. Users can set the desired temperature and monitor energy usage, ensuring they achieve the perfect balance between comfort and efficiency. The built-in diagnostic system helps users troubleshoot any issues quickly, maintaining the heater's performance and prolonging its lifespan.

Another significant characteristic of the Raypak 055B is its reliability. The heater is designed with a durable, rust-resistant cabinet that protects the internal components from the elements. This rugged construction makes the Raypak 055B an excellent choice for outdoor installations, ensuring longevity and reliable operation year-round.

The advanced airflow design in the Raypak 055B ensures a safe and efficient operation. The heater is equipped with a standard fan that aids in efficient operation while minimizing noise. Additionally, its low NOx emissions technology meets strict environmental regulations, making it an environmentally friendly option.

The Raypak 055B also includes an innovative ignition system for enhanced safety and convenience. The direct spark ignition eliminates the need for a standing pilot light, reducing gas consumption and further improving efficiency. The unit's freeze protection feature prevents damage during harsh winter conditions, ensuring that users can rely on it throughout the seasons.

In conclusion, the Raypak 055B stands out as a top choice for pool and spa heating solutions. With its combination of efficiency, durability, and advanced technology, it meets the demands of modern consumers looking for comfort without compromising on performance or sustainability. Whether you need to heat a residential pool or a commercial spa, the Raypak 055B is engineered to deliver exceptional results.
Top Page Image Contents