SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
CAMERA
AUTO FOCUS | ON |
ZOOM LIMIT | X128 |
ZOOM SPEED | MEDIUM |
LOW LIGHT LIMIT | 2 |
|
|
<ADVANCED SETTINGS> |
|
BACK |
|
EXIT |
|
ADVANCED SETTINGS
SHUTTER SPEED | AUTO |
AGC LIMIT | 25 |
AUTO IRIS | AUTO |
AUTO IRIS LEVEL | 66 |
AUTO IRIS PEAK | 8 |
AUTO SHARPNESS | ON |
SHARPNESS LEVEL | 26 |
AUTO WHITE BALANCE | ON |
R GAIN | 482 |
B GAIN | 678 |
BACKLIGHT COMP | OFF |
VIDEO LEVEL | HIGH |
BACK |
|
EXIT |
|
*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.
BACKLIGHT COMPENSATION (BLC)
If a bright backlight is present, the subjects in the picture may appear dark or as a silhouette. Backlight compensation enhances objects in the center of the picture. The dome uses the center of the picture to adjust the iris. If there is a bright light source outside of this area, it will wash out to white. The camera will adjust the iris so that the object in the sensitive area is properly exposed.
There are two backlight compensation settings:
ON | Backlight compensation is activated. |
OFF (default) | Backlight compensation is not activated. |
NOTE: If backlight compensation is ON, decrease the Auto Iris setting. Refer to the Auto Iris section.
VIDEO LEVEL
Set the video output to one of the following:
NORMAL | 1.0 volt |
HIGH (default setting) | 1.2 volt |
Quick Programming Guide
(See page 11)
21 |