Pelco DD53TC16-X manual Label Position

Label Position

SPECTRA III

LANGUAGEENGLISH

<SYSTEM INFORMATION> <DISPLAY SETUP>

<DOME SETTINGS> ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DISPLAY SETUP

PRESET LABEL	2 (SECS)
ZONE LABEL	2 (SECS)
ZOOM	2 (SECS)
AZIMUTH/ELEVATION	2 (SECS)
DIRECTION	OFF
ALARM MESSAGE	2 (SECS)

Labels can be placed anywhere on the monitor. This feature allows you to customize the appearance of your monitor screen.

The following labels are not set at fixed positions:

PRESET LABEL

ZONE LABEL

ZOOM RATIO - XXX.XX

AZIMUTH1/ELEVATION2 - XXX°/-XX°

DIRECTION - NE

ALERT MESSAGE3*

TITLE TEXT

To set a label position:

1.Use the joystick to position the cursor beside a label.

2.Press Iris Open.

<LABEL POSITIONS> RESTORE FACTORY DEFAULTS

BACK

EXIT

3.Use the joystick to move the label up, down, left, and/or right.

4.Press Iris Open.

5.Repeat steps 1 through 4 to position other labels.

LABEL POSITION

[ZONE LABEL-------]

[PRESET LABEL-------]

[ALERT MESSAGE-------]

[TITLE TEXT]

SAVE AND EXIT

CANCEL AND EXIT HELP

XXX°/-XX°

NE

XXX.XX

*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.

6.Position the cursor next to Save and Exit. Press Iris Open to save settings and exit menu.

1Azimuth is the pan angle from 0° to 359°.

2Elevation is the tilt position from 0° (horizon) to -90°.

3The alert message is the warning displayed on the monitor if pressure, temperature, or dew point inside the dome reach unacceptable levels.

16 C2446M-E (11/05)