SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
MOTION
AUTO FLIP | ON |
PROPORTIONAL PAN | ON |
PARK TIME (MINUTES) | 0 |
PARK ACTION | NONE |
SCAN SPEED (DEG/S) | 25 |
LIMIT STOPS | ON |
<SET MANUAL STOPS> |
|
<CLEAR MANUAL STOPS> |
|
<SET SCAN STOPS> |
|
<CLEAR SCAN STOPS> |
|
|
|
<SET AZIMUTH ZERO> |
|
<CLEAR AZIMUTH ZERO> |
|
BACK |
|
EXIT |
|
REFERENCE INFORMATION |
|
MANUAL LIMITS SET | NO |
SCAN LIMITS SET | NO |
*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.
AZIMUTH ZERO
Azimuth is the pan angle from 0° to 359°. Azimuth zero is the pan position you specify to be the 0° point. Azimuth zero is normally set to magnetic north. Once set, azimuth and compass readings are based on the set Azimuth Zero point.
To program azimuth zero:
1.Use the joystick to position the cursor beside SET AZIMUTH ZERO.
2.Press Iris Open.
3.Follow the directions displayed on the monitor.
To clear azimuth zero:
1.Use the joystick to position the cursor beside CLEAR AZIMUTH ZERO.
2.Press Iris Open.
3.Follow the directions displayed on the monitor.
Quick Programming Guide
(See page 11)
25 |