Schneider Electric ACECFR20200SE, ACECFR20101SE, ACECFR40200SE Electrical Connections

Page 25

Electrical Connections

The electrical connections required are the following:

•Power to Frame

•Control (remote display interface)

•Communication - Building Management System (BMS) - optional

Make all electrical connections in accordance with applicable industry guidelines as well as national and local codes.

Make all low-voltage connections, including data and control connections, with properly insulated wires. The low-voltage wires and connections must have at least 300V insulation.

DANGER

HAZARD OF ELECTRIC SHOCK

Use a voltmeter to ensure that power is turned off before making any electrical connections.

Failure to follow these instructions will result in death or serious injury.

NOTE: Three-phase electrical service is required. Electrical service must conform to national and local electrical codes.

EcoBreeze System Installation

21

Image 25

Contents EcoBreeze System Installation ManualSchneider Electric IT Corporation Legal Disclaimer Contents Electrical Connections Mechanical ConnectionsGeneral Information SafetyInspecting the Equipment Storing the equipment before installationModel identification label location Model IdentificationFrames ModulesHazard of Electric Shock Access Door and Panel OperationDescription Quantity 20 ft 40 ft Component IdentificationItem Description EcoBreeze Frame and ModulesRemote display interface Module frontSite Preparation Incoming power supply requirements DuctworkWater supply FoundationEnvironment Piping/plumbing diagram Refrigeration Wall or Other Obstruction Service accessFrame Weights and DimensionsLifting and Rigging InstallationPosition the EcoBreeze Mechanical ConnectionsUnwrap the equipment Remove the tension rods Lower Module drop-down box Water supply connection Drain AIR GAP Electrical Connections Hazard to Equipment and Personnel Power supply to EcoBreeze FrameDDC Panel 126 K4 N4 G4 198 193 195 190 196 197Building Management System Page Page Worldwide Customer Support