Power supply to EcoBreeze Frame

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

Turn off all power supplying this equipment before working on the equipment. All electrical work must be performed by licensed electricians. Practice Lockout/Tagout procedures. Do not wear jewelry when working with electrical equipment.

Failure to follow these instructions will result in death or serious injury.

WARNING

HAZARD TO EQUIPMENT AND PERSONNEL

Only Schneider Electric authorized personnel may energize the equipment.

Failure to follow these instructions can result in death, serious injury, or equipment damage.

1.Use a punch tool to create an access hole as needed for power supply wires entering the main power enclosure.

2.Attach the conduit connector to the access hole on the main power enclosure.

NOTE: A service loop is factory-installed in the main power enclosure.

3.If permitted by local and national codes, route the cable to the disconnect switch as shown. If local and national codes do not permit service loops, make all connections per code.

4.Connect the power wiring to the disconnect switch. Connect the phases as marked next to the disconnect switch.

5.Connect the ground wire to the grounding lug beside the disconnect switch.

L1 L2

L3 GND

SUPPLY

BLOWER

ACCESS

na3490a

22	EcoBreeze System Installation