INSTALLATION INSTRUCTIONS
INSTALLATION
IMPORTANT: ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER TO DATABADGE AND TECHNICAL SPECIFICATIONS AT THE FRONT OF THE BOOKLET. FOR DETAILS OF CHANGING BETWEEN GAS TYPES, SECTION 9, SERVICING.
1.CONTROL UPGRADE
1.1Your fire is fitted with a control valve that can be easily upgraded to battery powered remote control. This upgrade can be fitted by anyone capable of simple DIY jobs and requires no special training. This upgrade can be obtained through your local Gazco stockist.
1.2STANDARD REMOTE CONTROL This remote control can control the fire after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.
1.3IMPORTANT - there is a thermostatic version of the upgrade but this is NOT SUITABLE for open flame fires.
2.SAFETY PRECAUTIONS
2.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Please read all instructions before installation and use of this appliance.
2.2These instructions must be left intact with the user.
2.3Do not attempt to burn rubbish on this appliance.
2.4In your own interest, and those of safety, this appliance must be installed by a competent person in accordance with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.
2.5Keep all plastic bags away from young children.
3.UNPACKING
3.1Remove the appliance from its packaging, and check that it is complete and undamaged.
3.2Put the loose ceramic parts to one side so that they are not damaged during installation.
4.INSTALLATION - RADIANT FIRES
4.1Fix the rear leg strap. See Diagram 1.
1
AR0019
4.2Position the fire with the rear leg fully engaged under the rear leg strap. Fasten the front legs using the fixings supplied.
4.3“HAVE YOU PURGED THE GAS SUPPLY PIPES”. This is essential to expel any foreign matter that might get blown into the valve assembly causing blockages.
4.4Connect the 8mm gas supply pipe to the fire. See Diagram 2 & 3.
2
AR0944
4.5If the isolation tap is to be fitted under the fire, the GAZCO GC0060 provides a neat and easy solution. See Diagram 3A.
33A
12