Stovax 8455 manual Installation Instructions, Arrangement Of Fuelbed Components

INSTALLATION INSTRUCTIONS

INSTALLATION

5.6Carefully fit the convector box, feeding the piping through into the box. Secure the box to the wall, through the flange or base ensuring that the box is square in the opening. Any undulations or gaps between the convector box and the wall should be filled with a non-combustible material. Do not use silicone as it makes future removal almost impossible.

5.7Refit the fire assembly and front air guide back into the convector box. See Diagram 9.

9

AR0314

5.8HAVE YOU PURGED THE GAS SUPPLY PIPES.

This is essential to expel any foreign matter that might get blown into the valve assembly causing blockages.

5.9Connect the 8mm gas supply pipe to the fire. See Diagram 10.

10

AR0944

5.10Check the gas connections to the fire are sound. Light the fire and check all joints on the appliance.

5.11Check the appliance working pressure is correct. See databadge.

5.12Fit the fire trim to the convector box. See Diagram 11.

11

AR0303

5.13Fit the fret to the fire front using the two securing screws. See Diagram 12.

12

AR0311

5.14If the appliance is fitted with an alternative Gazco front please refer to the separate leaflet supplied with the front.

6.ARRANGEMENT OF FUELBED COMPONENTS

ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS

The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application. Protective clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area and always wash your hands before eating or drinking.

To ensure that the release of RCF fibres are kept to a minimum, during installation and servicing a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the appliance before and after working on it. When servicing the appliance it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.

RCF waste is classed as stable, non-reactive hazardous waste and may be disposed of at a licensed landfill site.

Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.

14