Paradigm SOUNDTRACK owner manual Connection, Setting UP the Soundbar, Setting UP the Subwoofer

IR Learning Codes

Your Soundtrack System is capable of learning certain codes from remote controls you already own, such as the volume code from your TV’s remote. Each code must be programmed in separately. To program, follow the steps below.

Step 1

Press and hold for 3 seconds the button on the soundbar’s Onboard Interface for the desired function to be programmed (eg. volume, source, mute, on/off).

Step 2

The Soundtrack’s LED will start to flash indicating that the system is now in ‘IR learning’ mode.

Step 3

Aim the source’s remote control at the front of the soundbar and press the corresponding function button on the source’s remote.

Step 4

Repeat from Step 1 to program each additional function.

NOTE: To learn a MUTE command from a remote control you already own, press the Sync button on top of the soundbar for 3 seconds then move to Step 2 above.

Your existing cable/satellite box remote control or TV remote control may use a code that the Soundtrack System cannot learn. In these instances you will have to use the remote control that came with your system or use a universal or learning remote control.

CONNECTION

For quick setup of soundbar and subwoofer, refer to the instructions in the Set-Up Guide.

SETTING UP THE SOUNDBAR

See Set-Up Guide.

SETTING UP THE SUBWOOFER

		(Shown) Back panel of
		Subwoofer. See pg. 8 for
1		description of numbered
	2	functions.

3

4

7