Samsung AQV12PWAN, AQV12PWAX manual Installing and connecting the drain hose of the indoor unit

Installing and connecting the drain hose of the indoor unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate. When passing the drain hose through the 65-mm hole drilled in the wall, check the followings:

Wall

Indoor unit

Drain hose

ENGLISH

The drain hose must not be bent.

The drain hose must NOT slant upwards.

5cm less

Keep a clearance of at least 5cm between the end of the drain hose and the ground.

The end of the drain hose must NOT be placed under water.

Ditch

Do not place the end of the drain hose in a hollow.

Drain hose installation

1.If necessary, connect the 2-meter extension drain hose to the drain hose.

2.If you use the extension drain hose, insulate the inside of the extension drain hose with a shield.

3.Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose tightly with a clamp.

• If you do not use the other drain hose hole,

block it with a rubber stopper.
4. When extending the Drain Hose, hold the end of Drain Hose and Extended
Hose, rotate and insert the drain hose into Extended hose for 15~20 mm. Make	Drain hose hole
sure the two hoses are firmly connected, there is no water leakage.

5.Connect the Drain Hose after using Foam Insulation to wrap the Extended Hose. Then, Use vinyl tape to wrap the each side of connection by 20mm .

		15~20 mm		20mm	20mm
				or more	or more
	Drain hose Extension	Drain hose	Extension
	drain hose
			drain hose	Vinyl Tape	Foam Insulation
6.	Pass the drain hose under the refrigerant pipe, keeping the drain			Shield
	hose tight.
7.	Pass the drain hose through the hole in the wall. Check if it slants
	downwards as seen in the picture.
8.	Using natural drainage method, check the drainage is normal.			Drain hose	Extension drain hose

33