REVERSING THE
REFRIGERATOR DOOR
Samsung recommends that reversing of
WARNING the door opening is only completed by Samsung approved Service providers.
This will be on a chargeable basis and at the customers expense.
Any damage caused while attempting to reverse the door opening is not covered under the appliance manufactures warranty.
Any repairs requested due to this circumstance will be completed on a chargeable basis at the customers expense.
Required Tools (Not provided)
3. Disconnect the wires and then remove 3 bolts.
Make sure your refrigerator is unplugged WARNING before handling electrical wires.
4.Remove the door from the lower hinge by carefully lifting the door straight up.
01 SETTING UP
|
|
| |
Phillips Head | Flat Head | 10 mm Socket | |
Wrench | |||
Driver (+) | Driver | ||
(for bolts) | |||
|
|
|
|
| |
8 mm |
| 4 mm Hex | |
Spanner | Wrench | ||
Socket Wrench | |||
(for hinge shaft) | (for bottom | ||
(for bolts) | |||
| hinge shaft) | ||
|
|
1. Remove 2 screws on the top of the refrigerator.
Screw
Refrigerator door is heavy, be careful
not to injure yourself when removing the CAUTION refrigerator door.
5.Separate the front leg cover after removing 2 screws.
Screw
2. Remove the plastic cover and make sure to | 6. Unscrew 3 bolts tightening the hinge and also | |
disconnect the wire connected to it. | ||
unscrew 3 bolts on the bottom left side by the front | ||
After removing the plastic cover, check the parts | ||
leg where removed hinge will be attached. | ||
for reversing the door. | ||
|
10mm
10mm
Be careful not to damage the electrical
CAUTION wires when removing the plastic cover.
setting up _7
13. 7. 2. 11:04 |