Samsung AR24HVSDEWKXMG, AR18HVSDEWKXMG, AR24HVSDEWKNMG manual English-56, Off / Blinking / On

2) Smart Install mode in progress

•88 Display : Progress will be displayed in 0~99..

•LED Display : Indicator on the indoor unit display will blink in sequence and then all indicators will blink.. (This will be repeated..)

TYPE	88 Display	LED Display
		LED1
Indoor unit indicator		LED2
		LED3

❋❋ Display may be different depending on the model..

3.Smart Install mode will end..

1)Smart Install mode will take approximately 7~13 minutes.. (Actual time may be different depending on the model..)

2)When Installation is successful : Smart Install mode will end with ringing sound and the air conditioner will be in standby status.. (Error message will not be displayed on the indoor unit indicator and the remote controller and buttons on the indoor unit will work normally..)

3)When installation is not successful : Smart Install mode will end and error message will be displayed on the indoor unit display..

1. Take necessary measures when error occurs.

--Refer to the service manual for necessary measures for each error that occurs.

2. Use the product after taking care of the error that occurs.

	Error indicator
		LED Display			Error	Measures to take by an installer
Display	LED 1	LED 2	LED 3
			/	/
					Communication Error	1.. Check the connection wire between indoor
					between Indoor and outdoor	and outdoor unit.. (whether the power cable and
					unit	communication cable is crossed or not)
					Error on indoor	1. Check the connection of the connector
					temperature sensor
,					Error on indoor heat	1. Check the connection of the connector
					exchanger
					Error on indoor fan	1. Check the connection of the connector
						2. Remove foreign substance (Check for the
					motor
						cause that restrains motor)
display and all						1. Re-set options
LED blinks					EEPROM/Option error
,
						1. Check if the service valve is completely open..
					Refrigerant flow blocking	2. Check if there's any blockage in the refrigerant pipe
					Error	which connects indoor and outdoor unit..
						3. Check for refrigerant leak..
						1. Check if sufficient amount of additional refrigerant
					Lack of Refrigerant (For	was charged for the pipe length that exceeds 7..5 m..
	 Above LED pattern is displayed when there's
						2. Check for refrigerant leak between valve and pipe
					Inverter model only)
	error is occurred on outdoor unit. Check the LED					connection..
	display on outdoor unit for the details.

❋❋ : Off / : Blinking / : On

English-56

MG_BETTER_INV_A3050_IB&IM_EN_DB68-05191A_UX.indd 56

2/17/2015 2:50:51 PM