Drilling a hole and fixing the indoor unit
ffDrill a hole with diameter of 60~65mm towards the outside.
fIfthe indoor unit is installed on unstable ground, it may be shaken by an external force or children, and eventually get knocked down. To prevent these accidents, you must fix the top or back of the indoor unit tightly with fixing brackets.
200mm | ø60~65mm |
150mm or less | |
|
Connecting pipes
• When installing, make sure there is no leakage. When recovering the refrigerant, stop the compressor first
WARNING before removing the connection pipe. If the refrigerant pipe is not properly connected and the compressor works with the service valve open, the pipe inhales the air and it makes the pressure inside of the refrigerant
cycle abnormally high. It may cause explosion and injury.
Installation procedure
1.Slightly hit the hole, for piping connection, with your hands or hammer.
410mm |
|
|
|
| |||
200mm |
| ||
|
|
|
|
Upper hole for drain hose
Hole for piping
connection
Drain hose
Piping
42
칠레향 FAC MEMORY 냉난방_IBIM_EN_03892A(5).indd 42 |