Drilling a Hole in the Wall
Drill a hole of 70mm in diameter to the outside.
The drilling should be done at a distance of less than 150mm from the floor facing the indoor unit.
ø70mm |
Less than |
150mm |
Drain Hose
Extend the drain hose to the drain hose connected to the drain pan, and fix it with the tape or a
Piping Material | Vinyl Chloride | |
(Outer diameter ø16mm) | ||
| ||
|
| |
Insulator | Foamed Polyethylene | |
|
|
Drain pan
Insulation
Band
Drain hose 
Indoor and outdoor unit connection
1.As the draining is of natural drain type, make the drain hose direct downward.
2.If there is any foreign substance in the drain plate, it may clog the drain pipe. Therefore, be sure to remove the foreign substance inside after installation.
3.After completion of installation, be sure to pour water into the drain pan, and then check the draining condition.(There is no problem in draining when the draining is completed within 20 seconds.)
Connecting the Pipe
The piping of this unit can be connected to the right, left, and rear side.
When you hit the area for piping connection slightly with a hammer, a hole is made.
After connecting the piping and drain hose, insert the rubber cap as shown in the figure.
Holes for piping connection (2 points)
Cover hole
AP50Q1C_IBIM_E