Cooling Your Room
You must select the Cool mode if you wish to adjust the :
Cooling temperature
Fan speed when cooling
1If necessary, press the 
(On/Off ) button.
Result: u The power indicator on the control panel comes on. u The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
Switched on
Stopped
lt will start up normally after three minutes.
2 If the is not displayed on the control panel, press the 
button on the remote control one or more times until it appears.
Result: u The indoor unit beeps each time you press the
button.
u The air conditioner runs in the Cool mode.
Note You can change modes at any time.
3To adjust the temperature, press the 
buttons on the remote
control or 
buttons on the control panel one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive.
Result: u Each time you press the | buttons: |
-The temperature is adjusted by 1°C.
-The indoor unit beeps.
uThe air conditioner starts cooling, provided that the room temperature is higher than the selected temperature.
uIf the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating.
4Select the fan speed by pressing the 
button on the remote
control or 
button one or more times until the required setting is displayed :
Automatic(rotated : 
)
Low
High
Turbo
Result: Each time you press the 
button, the indoor unit beeps.
5To control the direction of the air flow, refer to page 14.
AP50Q1C_IBIM_E