Samsung AP55Q1DNUMG, AP55Q1CNUMG manual Heating Your Room, Select the fan speed by pressing

Page 8

Heating Your Room

You must select the Heat mode if you wish to adjust the :

Heating temperature

Fan speed when heating

1 If necessary, press the (On/Off ) button.

Result: u The power indicator on the control panel comes on.

uThe indoor unit beeps.

IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:

Switched on

Stopped

lt will start up normally after three minutes.

2 If the is not displayed on the control panel, press the button on the remote control one or more times until it appears.

Result: u The indoor unit beeps each time you press the

button.

u The air conditioner runs in the Heat mode.

Note You can change modes at any time.

3To adjust the temperature, press the buttons on the remote

control or

buttons on the control panel one or more times

until the required temperature is displayed. Possible temperatures

are between 16°C and 30°C inclusive.

 

 

 

Result:

 

u Each time you press the

buttons:

 

 

 

 

- The temperature is adjusted by 1°C.

 

 

 

 

- The indoor unit beeps.

 

 

 

 

 

u The air conditioner starts heating, provided that the room

 

 

temperature is lower than the selected temperature.

 

 

 

u For the first 3~5 minutes, the fan may not operate to prevent

 

 

the cool air from running out of the indoor unit.

 

 

 

u If the room temperature reachs the set temperature, the air

 

 

conditioner stops heating, but the fan is still operating.

 

 

u The Defrost indicator( ) appears when frost forms on the

 

 

outdoor unit and disappears automatically after removing frost.

4 Select the fan speed by pressing the

button on the remote control

or

button one or more times until the required setting is displayed :

 

 

Automatic(rotated :

)

 

 

Low

 

 

 

 

 

High

 

 

 

Result:

 

Each time you press the

button, the indoor unit beeps.

5 To control the direction of the air flow, refer to page 14.

 

Note

 

You can't control the airflow direction when the fan

E-8

 

doesn't operate.

 

 

 

AP50Q1C_IBIM_E 32202-2.indd 8

2010-07-14 오후 4:42:06

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Air Conditioner Safety Precautions Contents View of the Unit Indoor UnitRemote Control-Buttons Inserting the Remote Control BatteriesOperating Preparation ForCooling Your Room Heating Your Room Select the fan speed by pressingSelecting the Automatic Operating Mode Changing the Room Temperature Quickly To adjust the temperature, press Operating to the Long DistanceRemoving Excess Humidity Airing Your Room When Adjusting the Air Flow Direction VerticallyAdjusting the Air Flow Direction Horizontally To Cancel the Off Timer Setting the Off TimerTopic Recommendation Other FunctionOperating Recommendations Temperature and Humidity Ranges If the air conditioner is used at ThenCleaning Your Air Conditioner Solving Common Problems Problem Explanation/SolutionTechnical Specifications Power SupplyAccessory Parts List Part NameDrain plug Cable tie Putty Piping Pipe band Cover hole ScrewOutdoor Unit Selection of Installation PlaceIndoor Unit Electrical Work AP50Q1C Series When using NFB No Fuse BreakerWhen using ELB Earth Leakage Circuit Breaker When connecting 3Phase 3wires 220V AC AP55Q1C/AP55Q1D SeriesInstallation Procedures Connection of Refrigerant Piping Flare ProcessingPipe Bending Tightening of Connection PartsDrain Hose Connecting the PipeDrilling a Hole in the Wall Air Purge Refrigerant Charging Check and Test Operation CheckTest Operation Packing and Unpacking Guide Outdoor unit How to connect your extended power cables Wire tube power cable Connection sleeveQuestions or COMMENTS?
Related manuals
Manual 36 pages 9.37 Kb
Top Page Image Contents