Samsung AQ12NBMDXSV, AQ12NBMD2/XSV manual Removing Excess Humidity

Page 14

Removing Excess Humidity

If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much.

1 If necessary, press the (On/Off) button.

Result: The 5 Way indicator on the indoor unit lights up.

The air conditioner starts up in the mode selected when the unit was last used.

The indoor unit beeps.

IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:

Plugged in

Stopped

It will start up normally after three minutes.

2 If the

is not displayed at the top of the remote control, press the

 

button on the remote control one or more times until it appears.

Result: The indoor unit beeps each time you press the

button.

 

The air conditioner runs in DRY mode.

 

You can change modes at any time.

 

3To adjust the temperature, press the buttons one or more times until the required temperature is displayed.

Possible temperatures are between 18°C and 30°C inclusive.

Result: Each time you press the buttons: - The temperature is adjusted by 1°C - The indoor unit beeps

The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically.

4To control the direction of the air flow, refer to pages 16 and 17.

E-14

Image 14
Contents OWNER’S Instructions Safety Precautions Contents View of the Unit Indoor UnitAir InletRear Air Outlet Connection Valve Remote Control Buttons and Display Getting Started Inserting the Remote Control Batteries Selecting with the Remote Control Even though you have lost your remote controlUsing with the indoor unit Way FunctionSelecting the Automatic Operating Mode SET TempCooling Your Room You can select the Heat mode only in the heat pump models Heating Your Room Except the cooling only modelsChanging the Room Temperature Quickly Removing Excess Humidity Airing Your Room Adjusting the Air Flow Direction Vertically RecommendationAdjusting the Air Flow Direction Horizontally Minutes to 24 hours Setting the On TimerTo Cancel the On Timer Setting the Off Timer To Cancel the Off TimerSetting the Sleep Timer To Cancel the Sleep TimerOperating Recommendations Topic RecommendationMode Outdoor Temperature Indoor Temperature Indoor Humidity Temperature and Humidity RangesCleaning Your Air Conditioner Have switched off the breaker used for the unitSolving Common Problems Model Indoor unit Power Supply Installing a Filter OptionTechnical Specifications Installation Manual Safety Precautions Fixing the Unit in Position Deciding Where to Install the Air Conditioner Indoor UnitMm or more Air Conditioner and Accessories Accessories in the Indoor Unit CaseFixing the Installation Plate Then follow StepsHeat pump models Connecting the Assembly CablePurging the Unit Cooling only modelsInstalling and Connecting the Indoor Unit Drain Hose To install the drain hose, proceed as followsInstalling and Connecting the Indoor Unit Assembly Piping PipeCutting/Extending the Piping Uneven ThicknessConnecting the Cables to the Outdoor Unit One electric cable must be connected to the outdoor unitChecking Correct Earthing Fixing the Unit in Position If you have used Then Connecting Up and Purging the CircuitUse Vacuum Pump as shown at the figure To check for gas leaks on Then, using a leak detector Check Performing Leak TestsPlacing the Indoor Unit in Position Checking and Testing Operations Explaining Operations to the Owner This AIR Conditioner is Manufactured by