Samsung AQ12NBMDXSV manual Air Conditioner and Accessories, Accessories in the Indoor Unit Case

Page 30

PREPARING THE INSTALLATION

Air Conditioner and Accessories

The following accessories are supplied with the air conditioner.

➢The quantities are indicated in parentheses.

Accessories in the Indoor Unit Case

Installation Plate (1)

Remote Control (1)

Batteries for

Remote Control (2)

Owner’s Instruction

Booklet & Installation

Manual (1)

OWNER’S

INSTRUCTIONS

The following connection accessories may be supplied, depending on the option. If they are not supplied, it is recommended that you collect them together before starting to install the

air conditioner.

Five-wire Assembly

Cable (1)

(AQ09/12✴ ✴ ✴)

Three-wire Assembly

Cable (1)

(AS09/12✴✴✴)

Assembly Piping,

Ø6.35mm by 5m (1)

Assembly Piping,

Ø9.52mm by 5m (1)

(✴✴09✴✴)

Assembly Piping,

Ø12.70mm by 5m (1)

(✴✴12✴✴)

PE T3 Foam Tube

Insulation (1)

Rubber LEG (4)

Vinyl Tape,

Width 50mm (1)

Cement Nail

Length 25mm (6)

Drain Plug (1)

M4 x 16 Tapped

Screws (10)

Pipe Clamps A (3)

Drain Hose,

length 2m (1)

Pipe Clamps B (3)

Putty 200g (1)

➢If these accessories are supplied, they are located in the accessory box.

E-30

Image 30

Contents OWNER’S Instructions Safety Precautions Contents View of the Unit Indoor UnitAir InletRear Air Outlet Connection Valve Remote Control Buttons and Display Getting Started Inserting the Remote Control Batteries Selecting with the Remote Control Even though you have lost your remote controlUsing with the indoor unit Way FunctionSelecting the Automatic Operating Mode SET TempCooling Your Room You can select the Heat mode only in the heat pump models Heating Your Room Except the cooling only modelsChanging the Room Temperature Quickly Removing Excess Humidity Airing Your Room Adjusting the Air Flow Direction Vertically RecommendationAdjusting the Air Flow Direction Horizontally Setting the On Timer To Cancel the On TimerMinutes to 24 hours Setting the Off Timer To Cancel the Off TimerSetting the Sleep Timer To Cancel the Sleep TimerOperating Recommendations Topic RecommendationMode Outdoor Temperature Indoor Temperature Indoor Humidity Temperature and Humidity RangesCleaning Your Air Conditioner Have switched off the breaker used for the unitSolving Common Problems Installing a Filter Option Technical SpecificationsModel Indoor unit Power Supply Installation Manual Safety Precautions Fixing the Unit in Position Deciding Where to Install the Air Conditioner Indoor UnitMm or more Air Conditioner and Accessories Accessories in the Indoor Unit CaseFixing the Installation Plate Then follow StepsHeat pump models Connecting the Assembly CablePurging the Unit Cooling only modelsInstalling and Connecting the Indoor Unit Drain Hose To install the drain hose, proceed as followsInstalling and Connecting the Indoor Unit Assembly Piping PipeCutting/Extending the Piping Uneven ThicknessConnecting the Cables to the Outdoor Unit One electric cable must be connected to the outdoor unitChecking Correct Earthing Fixing the Unit in Position Connecting Up and Purging the Circuit Use Vacuum Pump as shown at the figureIf you have used Then To check for gas leaks on Then, using a leak detector Check Performing Leak TestsPlacing the Indoor Unit in Position Checking and Testing Operations Explaining Operations to the Owner This AIR Conditioner is Manufactured by