COMPLETE THE
INSTALLATION
❒Stuff the wires into the junction box. Make sure none of the wires get pinched.
Slide the fixture onto the mounting
screws and tighten nuts.
| Junction |
Mounting | Box |
Surface |
|
Canopy |
|
❒Install light bulb (100 Watt maximum).
❒Install the lower glass assembly (if applicable). Secure with decorative screws.
❒After completing the tests, caulk between fixture canopy and mounting surface with silicone weather sealant.
LOWER ARM INSTALLATION
(4294 Only)
Model 4294 comes with a separate lower arm. Follow the directions below to attach the lower arm.
1. Complete the in- stallation steps above.
2. Using the decora- tive screws pro-
vided, secure the lower arm to the canopy and the
bottom of the low- er glass assem-
bly as shown.
TESTING
❒Turn on the circuit breaker and light switch.
Note: Sensor has a 1 1/2 minute warm up pe- riod before it will detect motion.When first turned on, wait 1 1/2 minutes.
Note: Meets the ENERGY STAR® guidelines when DualBrite® function is off.
❒Switch the
TEST 1 5 10 MIN | OFF 3 6 DUSK TO |
HOUR DAWN |
Avoid aiming the control at:
•Objects that change temperature rapidly, such as heating vents and air condition- ers. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the control.
•Nearby large,
150°
6 ft.
(1.8 m) 
30ft.
(9.1 m)
Maximum Range | Maximum |
| Coverage Angle |
The detector is less sensitive to motion di- rectly towards it and more sensitive to across motion.
MotionMotion
| Sensor |
Least Sensitive | Most Sensitive |
5 |