BM 2610031756 08-13_BM 2610031756 08-13 8/15/13 9:40 AM Page 8
JACKET CARE & mAINTENANCE
JACKET CARE & mAINTENANCE
To reduce the risk of injury, ! WARNING always unplug the battery
holster/controller and remove the battery pack and from the heated jacket before performing any maintenance. Never disassemble the heated jacket, battery pack or battery holster/controller. Contact a Bosch service facility for all repairs.
Never immerse the battery holster/ controller, battery pack or charger in liquid or allow liquid to flow inside them. Risk of electric shock and fire.
DO NOT CREASE HEATED CLOTHING BY PLACING ITEmS ON TOP OF IT WHEN STORING. Do not crush the heated jacket and avoid sharp folds. This may damage the electric wiring increasing the risk of shock and burns.
CLEANING HEATED JACKET
Remove all items from pockets, including the battery holster/controller, Battery and USB cable before washing.
!WARNING Follow Use and Care instructions on jacket tags.
Hand wash jacket only with cold water and hang to dry. Do not wring jacket, always allow to drip- dry completely.
Do not machine wash or machine dry even though the machine may include a hand wash or equivalent cycle. A risk of an electric shock or fire may result.
Do not use dry cleaning fluid or other cleaning solvents. Do not dry clean. Do not bleach. Cleaning fluids may have a deteriorating effect on the insulation of the heating element. Risk of electric shock, burns and fire.
Do not iron. Ironing may damage wire insulation leading to risk of shock and burns.
TROUBLE SHOOTING GUIDE | ||
Cause: | Corrective measure: | |
Jacket does not activate | Check that battery pack is completely charged. | |
| Check that the Heating Elements Power Cable is connected to | |
| the battery holster/controller. | |
| Hold the Power Button until the LED lights up “RED.” | |
Heating Zone does not work | Heating pads are located in three areas; left and right chest | |
| and center of back. If one area is not heating, contact Bosch | |
| Technical Service at | |
Jacket shuts off automatically | Your jacket is equipped with a thermal sensor to ensure it will | |
| not heat beyond designated temperatures to prevent possible | |
| injury. Allow the jacket to cool off for approximately 30 minutes | |
| and try to reactivate. | |
USB Port not producing power | Check that battery pack is charged. | |
|
| Plug in device and press the USB port “Wake- |
| ! WARNING | |
|
| up” button for three seconds. |
Check that your device does not require any more than 5 V
DC, 1 amp maximum output.
Unfortunately, not all devices can be tested for compatibility and your device may not be compatible.