Notes and cautions
In use | Cleaning and maintenance | ||||
|
| Note |
|
| Note |
|
| ||||
|
|
|
| ||
|
|
|
| ||
Safety device will cut off the power when the vacuum cleaner was on for more than 30 minutes without any button input. In this case,
press the [
] button on the body or unplug the power plug and then plug it again.
When you use the dusting brush or crevice tool, you may feel vibration from the vacuum cleaner.
Please do not press the button of dust bin handle when carrying the vacuum cleaner.
The operating noise may change once the safety device is activated to prevent the dust bin from getting detached.
–The circular tube on bottom of the dustbin prevents dust from spilling out.
To make the dust filter cleaner, add neutral detergent into lukewarm water and soak the filter for 30 minutes before washing it.
Do not wash the outlet filter with water.
To maintain the best performance of the outlet filter, replace them once a year.
To prevent floors from scratches, inspect condition of the brush and replace it if it is worn down.
Inspect the belt in the mini turbo to ensure that it is in good condition. If the belt is broken or cracked, replace it according to "To replace the belt" instructions.
Replacement filters are available at your local Samsung distributors.
Caution
When removing the power plug from the electrical outlet, grasp the plug, not the cord.
About storing
Note
Hold the power cord and then press the [
] button since you can get injured if the power cord may lose control while rewinding it.
If the power cord is not rewinding well, press
the [
] button again after pulling the power cord about 2~3 m
Caution
Store the vacuum cleaner in the shade to prevent deformation or discoloration.
Caution
Suction may reduce noticeably due to wrong reassembling of the dust filter.
Make sure the dust filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.
Dry the dust filter in the shade, not under sunlight, to prevent transformation or discoloration.
You may wash the dust bin with cold water.
When suction is noticeably reduced continuously or vacuum cleaner abnormally overheats, please clean the outlet filter.
Please contact a nearest service center if you cannot remove foreign matters from the hose.
If tool is required for cleaning, please be careful not to hurt the mesh.