Quadra-Fire CB1200-B owner manual Glass Replacement, Replacing Side Glass

Page 34

CB 1200 Pellet Stove

 

R

H. Glass Replacement

 

 

 

WARNING

 

Door Latch

 

• Glass is 5mm thick high temperature heat-

Top & Bottom Frame

 

 

resistant ceramic glass.

 

 

 

 

 

• DO NOT REPLACE with any other material.

 

 

 

• Alternate material may shatter and cause

 

 

 

injury.

Center Posts

 

 

 

 

 

• Remove door from appliance and place face down

 

Side

 

on a protected surface to avoid scratching the door.

Glass

 

Frame

 

• Remove all door rope.

 

 

 

1.

Replacing Center Glass

 

 

NOTE: DO NOT LET Air Wash Spacers fall down from

 

 

 

top frame when removing and replacing center

 

 

 

glass.

 

 

a.Be sure the appliance is allowed to cool, has been Figure 34.1 unplugged and the exhaust blower is off.

b.Using a nut driver remove the (5) bottom nuts and remove the bottom glass frame. Figure 34.2.

c. Slightly bend up and out of the way the 2 center posts

Remove Door Latch First

and slide the glass out the bottom.

and then Side Frame

d. Slide new glass in, reposition the 2 center posts and

 

re-install bottom glass frame.

 

e. Re-rope the door.

Door Frame

 

shown with no

2. Replacing Side Glass

Glass or Glass

NOTE: When removing the side glass with the door

Frames

 

latch, you must remove the door latch first

 

before removing the side frame. Use a pow-

 

ered Phillips head screw driver to remove the

 

4 screws.

Remove 5 nuts from Bottom Frame

a.Be sure the appliance is allowed to cool, has been unplugged and the exhaust blower is off.

b. Remove side glass frame.

Figure 34.2

 

 

 

 

c. Loosen the top and bottom frame and slightly bend

 

 

 

 

up and out of the way.

 

 

 

 

 

 

 

WARNING

d. Slide glass out the side and slide new glass in.

 

 

 

e. Re-install the side glass frame and tighten the top

 

 

 

Handle glass with care.

and bottom frames.

 

 

 

• Inspect the gasket to ensure it is

f. Re-install the door latch, if applicable, and re-rope

 

 

 

undamaged.

 

 

 

• Do NOT strike, slam or scratch glass.

the door.

 

 

 

• Do NOT operate appliance with glass

 

 

 

 

assembly removed.

 

•

Do NOT operate with glass cracked, broken or scratched.

 

 

 

 

 

Page 34

7014-082D

September 1, 2008

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Classic BAY 1200 Pellet Stove Hot glass will cause burnsBehind left side curtain on outside of hopper wall Testing Lab & Report NumberCB 1200 Pellet Stove Serial Number ModelTable of Contents Listing and Code Approvals Getting Started Design, Installation & Location ConsiderationsFire Safety Appliance LocationCB 1200 Pellet Stove Tools And Supplies Needed Inspect Appliance & Components and Pre-Use Check ListDimensions and Clearances Appliance DimensionsCB 1200 Pellet Stove Clearances to Combustibles UL and ULC CB 1200 Pellet Stove Hearth Pad Requirements UL and ULC Exception for Horizontal InstallationsHearth Pad Requirements Vent Information CB 1200 Pellet Stove Equivalent Feet of Pipe Pipe Selection ChartExample of 3 Elbow-Rear Vent Termination Calculaton 5Venting Systems AlcoveDegree Straight OutCB 1200 Pellet Stove Through The Wall CB 1200 Pellet Stove Vertical Through The Wall & VerticalMasonry Alternate MasonryMobile Home Appliance Set-Up Rear Installation Floor InstallationOutside Air Kit Instructions Installing the Top Vent Adapter CB 1200 Pellet Stove Top Vent Adapter InstallationRear Vent and Rear Vent to Top Vent Adapter Installation See FigureCB 1200 Pellet Stove Optional Brick Set Installation Brick Clip InstallationTop Log, Left Installing Logo Nickel OnlyCharred Areas in the Back RightTo install door Door InstallationCB 1200 Pellet Stove Thermostat Installation To adjust latchesOperating Instructions Fuel Size And Material General Operating InformationFeed Rate Adjustment Instructions Starting Your First FireFrequently Asked Questions CB 1200 Pellet Stove Ignition CyclesSymptom TroubleshootingPossible Cause Corrective Action Page Page Frequency Daily Weekly Monthly Yearly Quick Reference Maintenance Chart10Maintaining & Servicing Your Appliance Types of FuelCleaning Heat Exchanger Chambers & Drop Tube Cleaning Firepot with Cleaning Rod & Firepot ScraperCleaning Ash Pan Ash Removal from FireboxCleaning the Glass Cleaning Beneath Heat ExchangerCleaning Exhaust Path Cleaning the HopperCleaning the Top Vent Adapter Preparing Firebox for Non-Burn Season Frequency YearlyCB 1200 Pellet Stove High Ash Fuel Content Maintenance Convection Blower ReplacementInstall new blower Exhaust Blower Replacement Remove existing blowerRe-install blower to blower housing Glass Replacement Replacing Side GlassReference Materials Component Function & LocationSnap Disc #1 Convection Blower 145F Vacuum SwitchWiring Harness See .1 below Snap Disc #2 Thermostat Override 200FCleaning Rods Heat Exchanger Tubes CB 1200 Pellet Stove Component LocationsGlass Size Center 13-7/8 wide x 11 high CB 1200 Pellet Stove Exploded ViewsGlass Size Sides 8 wide x 11 high Nbr Description CB 1200 Pellet Stove CB 1200 Pellet Stove Service Parts and Accessories Item # Parts Alphabetical OrderItem # Service Parts Alphabetical Order Accessories ApplianceCB 1200 Pellet Stove Service And Maintenance Log Date of Service Performed By Description of ServiceCB 1200 Pellet Stove Homeowner’s Notes CB 1200 Pellet Stove Warranty Policy CONDITIONS, Exclusions & Limitation of LiabilityHearth & Home Technologies Limited Warranty Cont’d Contact Information
Top Page Image Contents