5. Lift up the freezer door from the rails.
ASSEMBLE THE FREEZER DRAWER
To reattach the drawer after you have moved the fridge to its final location, assemble parts in reverse order.
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can make final adjustments. Use a level to test if the refrigerator is level both side to side and back to front. If the refrigerator is not level, it will not be possible to get the doors perfectly even, which may cause moisture condensation and increased energy bills. Below is an example of how to level the refrigerator if the left side of the refrigerator is lower than the right side.
How to adjust the level
1.Open the freezer drawer and remove the lower basket. (See to page 7)
2. | Remove the two | 2 |
| screws ( 1 ) attached |
|
| to the cover leg front |
|
| ( 2 ) with a Philips | 1 |
| screwdriver (+). | |
|
| |
3. | Remove the cover |
|
| leg front ( 2 ) by lifting |
|
| the bottom part of the |
|
| cover leg front up and |
|
| pulling it out. |
|
4. Insert a |
| |
| screwdriver |
|
| notch on the left control lever, and turn it count | |
| clockwise to level the refrigerator. (You turn the | |
| lever clockwise to lower the refrigerator and | |
| counterclockwise to raise it.) |
|
Both control levers must be touching the CAUTION floor to avoid possible personal injury or
property damage because of tipping.
If the right side is lower, perform the same procedure, but with the right control lever.
It is difficult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments with the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.
MAKING MINOR ADJUSTMENTS BETWEEN DOORS
Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.
| Adjustment |
Fixed part | part |
|
The left door is fixed. To make minor adjustments between doors, adjust only the right door.
1.Pull out the freezer drawer ( 1 ), then you can see the lower hinge ( 2 ).
2.Insert a philips screwdriver (+) ( 3 ) into the shaft ( 4 ) of the lower hinge.
3.Adjust the height by turning a philips screwdriver (+) ( 3 ) clockwise ( DOWN ) or counterclockwise ( UP ).
When you turn a philips screwdriver (+)
counterclockwise (
), the door will move up.
(2)
(4)
(1)
Lever
10_ setting up
(3)(3)
2015. 5. 7. |
��
3:51