Radiance Direct Vent/Natural Vent Gas Heater
ST141
Fig. 63 Release the latches to remove the glass frame.
Gasket Replacement
The Radiance Gas Heater uses a ‘tadpole’ type gasket to seal between the glass panel and the frame. In time, this gasket can become brittle and compressed and should be replaced. New gasket is available from your dealer.
Shut off the gas supply and allow the stove to cool. Wear safety goggles and a dust mask.
1.Remove the Front, Glass Frame and Glass Panel. (Figs. 62 & 63) Remove the old gasket. Use a razor blade to separate the glass and gasket from the frame, and to clean the glass of any remaining cement or bits of gasket. Use a cold chisel if neces- sary.
2.Determine the correct length of gasket by laying it out around the edge of the glass. Allow an extra 1
- 2”
3.Starting on a long edge, remove about 6” of the pro- tective paper strip and apply the flat adhesive face of the gasket around the
4.Apply a thin bead of high temperature silicone rubber sealant along the inside corner of the glass frame, all around the perimeter. Place the flat gasketed side of the glass panel back into the steel frame. Pinch the rounded
5.Replace the glass frame and front panel as previ- ously described.
| ST179 |
Fig. 64 | Wrap the gasket material around the outside edge of |
the glass.
Inspect the Vent System Annually
Have the vent system inspected annually by a quali- fied technician. Shut off the main gas supply before inspecting the system. Both the inner exhaust pipe and the outer combustion supply pipe must be checked to
confirm that they are unblocked and in good condition.
Check the Gas Flame Regularly
To ensure that the stove is operating properly, check the flames periodically to confirm that they match Figure 65. The flames will be blue during the first
Do not use your stove if the flame pattern differs from that shown here. Contact your Vermont Castings dealer or a qualified technician for help.
Red |
|
Glow | |
| LG157 |
Fig. 65 | Correct flame pattern. |
3434 | 20004188 |