Amcor HW9KE, HWAM12KE, HWAM9KE Internal Unit, Attachment plate, Hole through the wall for the duct

Page 50

GB

INTERNAL UNIT

To reduce the risk of leakage the internal unit must be hung absolutely level. The water catcher in the internal unit with the condensation water drainage connected to it must be clean and free from any obstruction, so that the condensation water can drain off unhindered (otherwise risk of leakage).

Once the place for the internal unit has been determined, you can start fixing the internal unit. Note that fixing it is your own responsibility.

A. Attachment plate

Mount the attachment plate level on a firm base, measure well and draw holes for the screws.

TIP. Fix the plate not too firmly with a screw, put the plate in horizontal position with the help of a spirit level, and then mark the holes for the other screws. Take the screw out again, drill all holes, put plugs in and screw the plate tight.

Drill the 8 holes 6.4 mm (2.5”) wide and 30 mm deep. Use the additionally supplied plugs.

Fix the attachment plate firmly with the additionally supplied screws.

B. Hole through the wall for the duct

The hole with a diameter of 65 mm and slanting a bit towards the outside in a downward direction (10-15 mm) for better condensation water drainage, can be made inside the space of the hood and will thus remain out of sight. If necessary leading it through more to the left is possible. In that case cover troughs are available in specialist stores.

Area for the hole.

50

Image 50
Contents High Wall Split AIR Conditioner Waarschuwing FelicitatiesVeiligheidsaspecten Verwarmen WerkingGebruik uw airconditioner niet, als OntvochtigenToetsen AfstandsbedieningLCD display Gebruik van de afstandsbedieningTijd instellen BedieningAlgemeen KoelenTijdklok-uit functie Slaap modusAuto-modus Tijdklok-aan functieVAN Belang Filters Zet het apparaat uit en haal de stekker uit het stopcontactBegin Gebruiksperiode SchoonmakenEinde Gebruiksperiode Batterijen VervangenN NN NGebruik het juiste gereedschap Controleer de netspanningHoud de werkplek opgeruimd Draag een masker en oog- en oorbeschermingMeegeleverde onderdelen en gereedschap VeiligheidUW Airconditioner De plaats voor het binnendeel Aanbevolen Gereedschap EN HulpmiddelenWaar PLAATSEN? De plaats van het buitendeelGat door de muur voor de leiding BinnendeelBevestigingsplaat Ophangen ElektriciteitssnoerLeiding Aansluiten elektriciteit BuitendeelAfvoerpijpje Leidingen Controleer op lekkagePage Loskoppelencleaning Buitendeel Félicitations SécuritéChauffage Fonctionnement’utilisez pas le climatiseur, si DéshumidificationAffichage LCD TélécommandeUtilisation de la télécommande TouchesGénéralités CommandeMode ventilation Réglage de la fonction tempsFonction Arrêt temps Mode nuitMode Auto Fonction Marche tempsPlage de réglage de la fonction pompe à chaleur Remise en marche automatiquePlage de réglage du thermostat intérieur CapacitéFiltres Débrancher l’appareil et retirer la fiche de la priseFIN Dune Période Dutilisation Remplacement DES PilesEntretien Début Dune Nouvelle Période DutilisationN  2VFMMFQJoDFQPVSWPUSF$MJNBUJTFVSN  N Mesures DE Sécurité Votre Climatiseur Pièces et outils fournisEmplacement de l’unité intérieure Équipement ET Outillage RecommandésChoix DE Lemplacement Emplacement de l’unité extérieureTrou dans le mur pour le passage de la conduite Unité IntérieurePlaque de fixation Suspension Cordon électriqueConduites Raccordement électrique Unité ExtérieureTube d’évacuation Fixer l’unité extérieure Contrôler pour fuite Page Dépose DE Lunité Extérieure Safety Instructions Thank YOUHeating HOW IT WorksDo not use your air conditioner when DehumidifyingButtons Remote ControlUsing of the remote control Operation Timer off function Sleep modeAuto mode Timer on functionCapacity Range of internal thermostatRange of heat pump function Emergency startTurn the appliance off and remove the plug from the outlet Start of Period of USE CleaningEND of Period of USE Replacing the BatteriesInstallation Guide Safety Aspects Additionally supplied parts and tools SafetyYour AIR Conditioner Place for the internal unit Where to PUT the APPLIANCE?Recommended Tools and Implements Place of the external unitHole through the wall for the duct Internal UnitAttachment plate Mounting Mains leadDuct Drainage pipe Connecting the electricityExternal Unit Fixing the external unitDucts Check for leakagePage Disconnecting the External Unit Guarantee does not cover multiple installationBinnenapparaat EER LabelsFabrikant Buitenapparaat 38/52Inside unit 38/53Manufacturer Outside unit Plaque Signalétique Rating Label Plaque Signalétique Israel