Majestic Appliances RDV4136 Remote ON/OFF Switch, Installation RN/RP Models

Page 8

RDV4136 Series Direct Vent Gas Fireplace

1/2” Gas Supply

1/2” NPT X 1/2” Flare Shut-off Valve

3/8” Flex line (from valve)

FP297A

Fig. 5 Typical gas supply installation.

Always check for gas leaks with a mild soap and water solution. Do not use an open flame for leak testing.

The gas control is equipped with a captured screw type pressure test point, therefore it is not necessary to pro- vide a 1/8” test point up stream of the control.

When using copper or flex connector use only approved fittings. Always provide a union when using black iron pipe so that the gas line can be easily disconnected for burner or fan servicing . See gas specifications for pres- sure details and ratings.

The fireplace valve must not be subjected to any test pressures exceeding 1/2 psi. Isolate or disconnect this or any other gas appliance control from the gas line when pressure testing.

Remote ON/OFF Switch

Installation: RN/RP Models

1.Thread the wiring through holes on the end panels of appliance. Take care not to cut wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the switch into the receptacle box.

3.Connect the other ends of the wire to the gas control valve. (Fig. 6)

Remote ON/OFF Switch or Thermostat or Remote Control

TP

Gas Control

TH

Valve

TP

 

TH

 

 

FP1224

Fig. 6 Remote switch wiring diagram for RN/RP models.

Remote ON/OFF Switch

Installation: IN/IP Models

1.Thread the wiring through holes on the end panels of appliance. Take care not to cut wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the switch into the receptacle box.

3.Connect the two (2) wires from wall switch to the two (2) brown wires from the control module marked SW1. Be sure to move the Remote/Off switch on the control module to the OFF position. (Fig. 7)

NOTE: The remote does not work in this configu- ration.

Remote

Switch

SW1

SW1

FP1832

Fig. 7 Remote switch wiring for IN/IP models.

8

10010618

Image 8
Contents Builder Top Vent Direct Vent Models RDV4136 Table of Contents Ansi Z21.88-2005 / CSA Vented Gas Fireplace Heaters Installation & Operating InstructionsRDV4136 Certified To Requirements for the Commonwealth of Massachusetts Gas Equipment Venting System not ProvidedFireplace Dimensions Mantel Chart Locating Your FireplaceClearance to Combustibles MantelsGas Line Installation HearthFraming and Finishing Final FinishingInstallation IN/IP Models Remote ON/OFF SwitchInstallation RN/RP Models EB-1 Electrical Box EB-1 receptacleGeneral Venting Location of Vent TerminationCanadian Installations1 US Installations2 General Venting Information Termination LocationCanadian Installations USA InstallationsGeneral Information on Assembling Vent Pipes Flex Vent PipesHow to Use the Vent Graph Twist Lock PipesExample a Example BInstall baffle to the deflector Vertical Sidewall ApplicationsVertical Sidewall Installation Twist Lock Pipe Zero clearance sleeve is only required for combustible wallsAlways install horizontal venting on a level plane Vertical height requirementStep Vertical Sidewall Installation Flex Vent PipeBelow Grade Installations Vertical Through-the-Roof Installation Vertical Through-the-Roof ApplicationsMin 610 mm Venting Components Window Frame Assembly Removal Glass CleaningOperating Instructions Glass InformationInstallation of Logs, Lava Rock & Ember Material Log InstallationLog Identification Chart LogsEmber Material Left Cross Log Right Cross Log Rear Log Front Flame Characteristics Correct pilot flame appearanceTo Turn Off Gas To Heater Lighting and Operating InstructionsFor Fireplaces Equipped with the SIT 820 Valve Lighting & Operating Instructions For Fireplaces equipped with AF4000 Gas ValveLighting Instructions Turning Off the Gas to the ApplianceTroubleshooting AF4000 ValveTroubleshooting AF4000 Valve Igniter operationAF4000 Valve Face Troubleshooting Honeywell VS8421 Remove Window Frame Assembly Before Service WorkNova SIT820 Valve Burner Orifice ConversionSkyTech Valve Pilot Orifice Conversion Injector Orifice Size MatrixMaintenance Cleaning the Standing Pilot Control SystemLogs May Be HOT Burner and Burner CompartmentRDV4136 Units GFSJ5J1RP RDV4136 Description RDV4136Fuel Conversion Kits Optional Accessories Fan AssemblyHard direct Wire Hook Up Wiring InstructionsRemote Controls Back-up Battery KitCeramic Refractory Panels Porcelain Steel BackLimited Lifetime Warranty Efficiency Ratings