Majestic Appliances RDV4136 Operating Instructions, Glass Information, Glass Cleaning

Page 21

RDV4136 Series Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

The use of any non-approved replacement glass will void all product warranties.

Care must be taken to avoid breakage of the glass.

Do not operate appliance with glass front removed, cracked or broken.

Replacement glass (complete with frame window) is available through your CFM Corporation dealer and should only be installed by a licensed qualified service person.

�������

��������������

������������

������������������

�������������

��������������������

���������������

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot)

2.If the unit has been operating allow time for the components to cool.

3.Remove the valve access panel. (Fig. 37)

4.Rotate the two clamps securing the lower edge of the frame by pulling out on the handles. (Fig. 38)

5.Tilt the glass frame out slightly at the bottom, lift the frame up and away from the fireplace.

6.To replace the glass frame reverse the procedure.

Valve

Valve Access Panel

FP1847

Fig. 37 Remove valve access panel.

Glass

Frame

Fire- place Front

Clamps

Glass

Panel

Glass Panel

Pull

Clamp

Hook

G584-501

Fig. 38 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean the glass. During start-up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to the glass surface.

Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas fireplace glass cleaner) within the first few weeks of operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean the glass after the first two weeks of operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam glass.

10010618

21

Image 21
Contents Builder Top Vent Direct Vent Models RDV4136 Table of Contents Installation & Operating Instructions RDV4136 Certified ToAnsi Z21.88-2005 / CSA Vented Gas Fireplace Heaters Gas Equipment Venting System not Provided Requirements for the Commonwealth of MassachusettsFireplace Dimensions Locating Your Fireplace Mantel ChartClearance to Combustibles MantelsHearth Gas Line InstallationFraming and Finishing Final FinishingRemote ON/OFF Switch Installation RN/RP ModelsInstallation IN/IP Models EB-1 receptacle EB-1 Electrical BoxLocation of Vent Termination General VentingGeneral Venting Information Termination Location Canadian Installations1 US Installations2USA Installations Canadian InstallationsGeneral Information on Assembling Vent Pipes Flex Vent PipesTwist Lock Pipes How to Use the Vent GraphExample a Example BVertical Sidewall Applications Install baffle to the deflectorZero clearance sleeve is only required for combustible walls Vertical Sidewall Installation Twist Lock PipeVertical height requirement Always install horizontal venting on a level planeVertical Sidewall Installation Flex Vent Pipe Below Grade InstallationsStep Vertical Through-the-Roof Applications Vertical Through-the-Roof InstallationMin 610 mm Venting Components Glass Cleaning Window Frame Assembly RemovalOperating Instructions Glass InformationLog Installation Installation of Logs, Lava Rock & Ember MaterialLog Identification Chart LogsEmber Material Left Cross Log Right Cross Log Rear Log Front Correct pilot flame appearance Flame CharacteristicsLighting and Operating Instructions For Fireplaces Equipped with the SIT 820 ValveTo Turn Off Gas To Heater For Fireplaces equipped with AF4000 Gas Valve Lighting & Operating InstructionsLighting Instructions Turning Off the Gas to the ApplianceAF4000 Valve TroubleshootingIgniter operation Troubleshooting AF4000 ValveAF4000 Valve Face Remove Window Frame Assembly Before Service Work Troubleshooting Honeywell VS8421Burner Orifice Conversion SkyTech ValveNova SIT820 Valve Injector Orifice Size Matrix Pilot Orifice ConversionCleaning the Standing Pilot Control System MaintenanceLogs May Be HOT Burner and Burner CompartmentRDV4136 Units GFSJ5J1RP Description RDV4136 RDV4136Fuel Conversion Kits Fan Assembly Optional AccessoriesHard direct Wire Hook Up Wiring InstructionsBack-up Battery Kit Remote ControlsCeramic Refractory Panels Porcelain Steel BackLimited Lifetime Warranty Efficiency Ratings