INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT
6
7
8
9
Pilot
Hole
Drill a pilot hole inside of the traced circle so that a jigsaw can be used to cut the holes out.
Use a jigsaw to cut the holes out of the wall and discard the inner circle debris. The wall is now prepared for the installation of the unit.
Pivot and remove casing door. Remove two screws from the back inside of the unit and detach the wall mounting plate from outside back of the unit.
Locate the studs in the wall and use at least four (4) wood screws to attach the wall mounting plate to the wall.
If installing onto drywall (not into a stud), anchors must be used.
Page 19 |