Bosch Appliances Comprehensive Guide for Bosch F220-P and the F220 Series Detector Heads

Page 5

F220 Series Detectors with F220-B6RS Bases

General Information en 5

 

 

2.2F220 Series Detectors

2.2.1About F220 Series Detector Heads

The F220 Series Detector Heads listed inTable 2.1 each require an F220-B6 Series Base.

WARNING! The F220-PTHC detects carbon monoxide

! (CO) as a component of a fire. Do not use the F220-PTHC as a stand-alone CO detector.

F220-135

Electronic heat detector 135°F (57°C), fixed

temperature and rate-of-rise

 

 

 

F220-135F

Electronic heat detector 135°F (57°C), fixed

 

temperature only

 

 

F220-190F

Electronic heat detector 190°F (88°C), fixed

temperature only

 

 

F220-P

Photoelectric smoke detector

 

 

F220-PTH

Photoelectric smoke detector with integral 135°F

(57°C) heat sensor

 

 

 

 

Photoelectric smoke detector with integral 135°F

F220-PTHC

(57°C) heat sensor and CO enhanced smoke

 

detection

 

 

Table 2.1 F220 Series Detector Heads

Bosch Security Systems, Inc.

Installation Manual

F.01U.029.847 -01 2007.02

Image 5
Contents F220 Series Detectors with F220-B6RS Base Trademarks Required Maintenance and TestingLegal Compatible Control Panels General InformationBase Features About F220 Series Detector Heads F220 Series Detectors3 F220 Series Heat Detector Heads 2 F220 Series Detector Features4 F220 Series Smoke Detector Heads Technical SpecificationsGeneral Specifications Base Specifications Install the BasesDetector Specifications Electrical SupervisionPage Loop Wiring Specifications Wire the BasesTerminal Connections EOL ResistorsFour-wire Loop Termination Wire Optional Remote AnnunciatorsWire F220-B6RS Sounder Bases NAC Configurations Local Configurations F220-B6RS Local Configuration DIP Switch Settings D275 Wire F220-B6E Power Supervision Base Wire Power Supervision ModulesF220-B6E D275 Wire D275 Power Supervision ModuleOptional Locking Bar Install the Detector HeadsMount the Detector Heads LED Keyed. Do not force them onto the mounting bases Detector HeadSet Detector Modes Test ModeSensitivity Mode Flash Rate and Trouble Indication Set CleanMe FeatureInspect the Installation Test the InstallationTest Each Detector Activate an Alarm at Each DetectorReset the Control Panel Test any CO Sensors Test the Alarm LoopPerform Nfpa 72 Required Testing USA