Bosch Appliances F220-B6RS installation manual

Page 9

F220 Series Detectors with F220-B6RS Bases

Install the Bases en 9

 

 

Power Supervision Base can be used as the last base on a loop in four-wire systems to provide power supervision.

NOTE! Follow NFPA 72 guidelines for mounting locations.

i For commercial and industrial installations, 30 ft (9 m) spacing between smoke detectors is recommended.

1.Release the mounting skirt from the mounting base. Use a screwdriver at the location of the snap locks (refer to Figure 2.1, item 12, page 4) to release the mounting skirt.

2.Run all system wiring (refer to Section 3.2 Wire the Bases on page 10).

3.Mount the base using the two oblong mounting holes. Fits 4 in. square, octagon, AB, and single-gang back boxes.

NOTE! Depending on local regulations, you can surface

i mount the bases using anchors, mollies, or wing nuts, or you can mount directly on back boxes.

NOTE! The electrical box must be large enough to

i accommodate the number and size of conductors specified by the National Electrical Code or any local authorities having jurisdiction (AHJ).

4.Tighten the base to the mounting surface. Tighten only until snug; not distorted.

Bosch Security Systems, Inc.

Installation Manual

F.01U.029.847 -01 2007.02

Page 8 Page 10
Image 9
Page 8 Page 10
Contents F220 Series Detectors with F220-B6RS Base Required Maintenance and Testing LegalTrademarks Compatible Control Panels General InformationBase Features About F220 Series Detector Heads F220 Series Detectors3 F220 Series Heat Detector Heads 2 F220 Series Detector FeaturesTechnical Specifications General Specifications4 F220 Series Smoke Detector Heads Base Specifications Install the BasesDetector Specifications Electrical SupervisionPage Loop Wiring Specifications Wire the BasesTerminal Connections EOL ResistorsWire Optional Remote Annunciators Wire F220-B6RS Sounder BasesFour-wire Loop Termination NAC Configurations Local Configurations F220-B6RS Local Configuration DIP Switch Settings D275 Wire F220-B6E Power Supervision Base Wire Power Supervision ModulesF220-B6E D275 Wire D275 Power Supervision ModuleInstall the Detector Heads Mount the Detector HeadsOptional Locking Bar LED Keyed. Do not force them onto the mounting bases Detector HeadTest Mode Sensitivity ModeSet Detector Modes Flash Rate and Trouble Indication Set CleanMe FeatureInspect the Installation Test the InstallationActivate an Alarm at Each Detector Reset the Control PanelTest Each Detector Test the Alarm Loop Perform Nfpa 72 Required TestingTest any CO Sensors USA
Top Page Image Contents