Finisar AN-2030 specifications DC Electrical Characteristics, Vcc = 3.15V to

AN-2030: Digital Diagnostic Monitoring Interface for Optical Transceivers							F i n i s a r
DC ELECTRICAL CHARACTERISTICS						( Vcc = 3.15V to 3.60V)
PARAMETER	SYMBOL	CONDITION	MIN	TYP		MAX	UNITS		NOTES
Input Leakage (SDA,	ILI		-1		+1		μA	2
SCL)
Input Logic 1 (SDA,	VIH		0.7Vcc			Vcc+0.5	V	1
SCL)
Input Logic 0 (SDA,	VIL		GND-0.5			0.3Vcc	V	1
SCL)
Low Level Output	IOL1	0.4V	3				mA	1
Current (SDA)	IOL2	0.6V	6				mA	1
AC ELECTRICAL CHARACTERISTICS						( Vcc = 3.15V to 3.60V)
PARAMETER	SYMBOL	CONDITION	MIN	TYP		MAX	UNITS		NOTES
SCL clock frequency	fSCL		0			400	kHz		*,3
			0			100			**
Bus free time between	tBUF		1.3				μs		*,3
STOP and START			4.7						**
condition
Hold time (repeated)	tHD:STA		0.6				μs		*,3,4
START condition			4.0						**
Low period of SCL	tLOW		1.3				μs		*,3
clock			4.7						**
High period of SCL	tHIGH		0.6				μs		*,3
clock			4.0						**
Data hold time	tHD:DAT		0			0.9	μs		*,3,5,6
			0						**
Data set-up time	tSU:DAT		100				ns		*,3
			250						**
Start set-up time	tSU:STA		0.6				μs		*,3
			4.7						**
Rise time of both SDA	tR		20+0.1CB			300	ns		*
and SCL signals						1000			**
Fall time of both SDA	tF		20+0.1CB			300	ns		*
and SCL signals						300			**
Set-up time for STOP	tSU:STO		0.6				μs		*
condition			4.0						**
Capacitive load for	CB					400	pF
each bus line
EEPROM write time	TW			10			ms

*Fast mode

**Standard mode

Notes

1.All voltages are referenced to ground.

2.Input levels equal either Vcc or GND.

3.The output must be configured to source.

4.The output must be configured to have pull-up resistance enabled.

5.This is the time for one comparison. The cycle is multiplied by 3.

6.This parameter is measured with maximum output current.

9/26/02 Revision D Page 34