New Buck Corporation 32 manual Alcove Installation, For Your Safety, Wall

Page 11
ALCOVE INSTALLATION

ALCOVE INSTALLATION

CAUTION: READ ENTIRE MANUAL BEFORE INSTALLING HEATER.

1.For clearances, see Figure 3. The minimum clearances must be met.

2.For “Installation and Gas Connection”, see page 17.

FOR YOUR SAFETY:

WHAT TO DO IF YOU SMELL GAS

-Do not try to light appliance.

-Do not touch any electrical switch. -Do not use telephone in building.

-Call your gas supplier immediately, from a neighbor’s phone. Follow the gas supplier instructions.

-If you cannot reach your gas supplier, call the Fire Department.

-Do not store or use gasoline or any other flammable vapors or liquids in the vicinity of this appliance or any other appliance.

NOTE: The depth of the alcove must allow a 4" minimum clearance at the rear. The width of the alcove must allow a 5” clearance on the right side and the left side. The height of the alcove must allow for a 10” clearance form the top of the heater to the ceiling of the alcove. The front edge of the heater must meet the front of the alcove, and have a minimum of 24” to any combustible material.

 

WALL

 

 

NOTE:

 

 

DIMENSIONS SHOWN ARE

 

 

MINIMUM CLEARANCE TO

4"

5"

COMBUSTIBLE WALL.

 

 

 

 

STOVE

 

FLOOR

 

 

PROTECTOR

 

 

10"

Figure 3

Page 9

Image 11
Contents VENT-FREE MODELFREESTANDING FIREPLACE OR WITH AN OPTIONAL WOODEN SURROUNDPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa LEFT SIDE FigureCEILING WALL7.Place logs on the burner base as shown on page WALL FREESTANDING INSTALLATION MODEL 32 FSWALL WALL ALCOVE INSTALLATIONFOR YOUR SAFETY Installation” for minimum clearances INSTALLATION OF MODEL 32 WSWS ASSEMBLY INSTRUCTIONS WITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32NOTE: See “Producing Adequate Ventilation” page INSTALLATION IN RESIDENTIALOR AFTER-MARKETMOBILE HOMES DETERMINING FRESH-AIRFLOW FOR HEATER LOCATION PRODUCING ADEQUATE VENTILATIONVent-freeheater VENTILATION AIR FROM INSIDE BUILDING VENTILATION AIRVENTILATION AIR FROM OUTDOORS REAR LOG FRONT LOG PREPARING LOG KITTOP RIGHT TOP LEFTFLAME GAS CONNECTIONGAS PRESSURE CHECK WHAT TO DO IF YOU SMELL GAS FOR YOUR SAFETY, READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS MILLIVOLT VALVE ITT LIGHTING INSTRUCTIONS PILOT BURNER TO TURN OFF GAS TO APPLIANCEIGNITOR ELECTRODE THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDUREOR MANUAL VALVE SIT FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTION MODULATING VALVE SIT LIGHTING INSTRUCTION Page 12.Close access panel door13.Turn on all electrical power to the appliance 15seconds MANUAL LIGHTING PROCEDURETHERMOSTAT CONTROL OPERATION FLAME FLAME CHECKWIRING DIAGRAM CLEANING IMPORTANT SAFEGUARDSTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED SERVICING REPAIR PARTSPART NUMBER REPLACEMENT PARTSKEY# PART DESCRIPTIONITTGENERAL CONTROLS PART NUMBER REPLACEMENT PARTSKEY# PART DESCRIPTIONPILOT 5 6 13Page NEW BUCK CORPORATION LIMITED WARRANTY MODEL FP-32Page