New Buck Corporation 32 manual Installation In Residential, Or After-Marketmobile Homes

Page 13

INSTALLATION IN RESIDENTIAL

EXPLODED VIEW OF MODEL 32 (WS)

WOODEN SURROUND BASE (HEARTH)	(SHOWN AS VIEWED FROM REAR OF SURROUND)

INSTALLATION IN RESIDENTIAL

OR AFTER-MARKET MOBILE HOMES

CHECK GAS TYPE:

THIS APPLIANCE IS ONLY FOR USE WITH THE TYPE OF GAS INDICATED ON THE RATING PLATE. THIS APPLIANCE IS NOT CONVERTIBLE FOR USE WITH OTHER GASES.

INSTALLATION SUPPLIES:

Before installing the heater, gather the following materials:

-	external regulator	-	ground joint union
	(supplied by installer for propane)	-	sediment trap
- piping (check local codes)		-	tee joint
-	manual shutoff valve*	-	pipe wrench
-	test gauge connection*	- sealant (resistant to LP gas)

*An C.S.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional C.S.A. design-certified manual shutoff valve from your dealer.

NOTE: See “Producing Adequate Ventilation” page 12.

.THIS APPLIANCE MAY BE INSTALLED IN AN AFTERMARKET*, PERMANENTLY

LOCATED, MANUFACTURED (MOBILE) HOME, WHERE NOT PROHIBITED BY LOCAL CODES.

*After Market: Completion of sale, not for the purpose of resale from the manufacturer.

Page 11

Image 13

Contents FREESTANDING FIREPLACE OR WITH AN MODELOPTIONAL WOODEN SURROUND VENT-FREEPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa CEILING FigureWALL LEFT SIDE7.Place logs on the burner base as shown on page WALL FREESTANDING INSTALLATION MODEL 32 FSWALL FOR YOUR SAFETY ALCOVE INSTALLATIONWALL WS ASSEMBLY INSTRUCTIONS INSTALLATION OF MODEL 32 WSWITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32 Installation” for minimum clearancesOR AFTER-MARKETMOBILE HOMES INSTALLATION IN RESIDENTIALNOTE: See “Producing Adequate Ventilation” page DETERMINING FRESH-AIRFLOW FOR HEATER LOCATION PRODUCING ADEQUATE VENTILATIONVent-freeheater VENTILATION AIR FROM INSIDE BUILDING VENTILATION AIRVENTILATION AIR FROM OUTDOORS TOP RIGHT PREPARING LOG KITTOP LEFT REAR LOG FRONT LOGFLAME GAS CONNECTIONGAS PRESSURE CHECK LIGHTING INSTRUCTIONS MILLIVOLT VALVE ITT FOR YOUR SAFETY, READ BEFORE LIGHTINGWHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS IGNITOR ELECTRODE TO TURN OFF GAS TO APPLIANCEPILOT BURNER THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDURELIGHTING INSTRUCTION MODULATING VALVE SIT FOR YOUR SAFETY READ BEFORE LIGHTINGOR MANUAL VALVE SIT LIGHTING INSTRUCTION 13.Turn on all electrical power to the appliance 12.Close access panel doorPage THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDURE15seconds FLAME FLAME CHECKWIRING DIAGRAM CLEANING IMPORTANT SAFEGUARDSTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED SERVICING REPAIR PARTSKEY# REPLACEMENT PARTSPART DESCRIPTION PART NUMBERITTGENERAL CONTROLS KEY# REPLACEMENT PARTSPART DESCRIPTION PART NUMBERPage 5 6 13PILOT NEW BUCK CORPORATION LIMITED WARRANTY MODEL FP-32Page