New Buck Corporation 32 manual Wiring Diagram

Page 30

WIRING DIAGRAM

WIRING DIAGRAM

NOTE: #PESBR084 Blower Motor Rating: 120 volts/60HZ/1.1 Amps.

NOTE: For convenience, allow licensed electrician to install properly grounded 3-plug receptacle near unit.

MOTOR

JUMPERTHERMOSTAT

JUMPER

GREEN

JUMPER

WHITE

BLACK

RHEOSTAT

POWER CORD

BLACK

NOTE: “If any of the original wire as supplied with the gas appliance must be replaced, it must be replaced with a wire of at least a 105o C. temperature rating.”

NOTE: Installation and repair should be done by a qualified service person. This heater should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments and circulating air passageways of the heater be kept clean.

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.

Verify proper operation after servicing.

Page 28

Image 30

Contents OPTIONAL WOODEN SURROUND MODELFREESTANDING FIREPLACE OR WITH AN VENT-FREEPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa WALL FigureCEILING LEFT SIDE7.Place logs on the burner base as shown on page FREESTANDING INSTALLATION MODEL 32 FS WALLWALL ALCOVE INSTALLATION FOR YOUR SAFETYWALL WITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32 INSTALLATION OF MODEL 32 WSWS ASSEMBLY INSTRUCTIONS Installation” for minimum clearancesINSTALLATION IN RESIDENTIAL OR AFTER-MARKETMOBILE HOMESNOTE: See “Producing Adequate Ventilation” page PRODUCING ADEQUATE VENTILATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATIONVent-freeheater VENTILATION AIR VENTILATION AIR FROM INSIDE BUILDINGVENTILATION AIR FROM OUTDOORS TOP LEFT PREPARING LOG KITTOP RIGHT REAR LOG FRONT LOGGAS CONNECTION FLAMEGAS PRESSURE CHECK FOR YOUR SAFETY, READ BEFORE LIGHTING LIGHTING INSTRUCTIONS MILLIVOLT VALVE ITTWHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCE IGNITOR ELECTRODEPILOT BURNER MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATIONFOR YOUR SAFETY READ BEFORE LIGHTING LIGHTING INSTRUCTION MODULATING VALVE SITOR MANUAL VALVE SIT LIGHTING INSTRUCTION 12.Close access panel door 13.Turn on all electrical power to the appliancePage MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATION15seconds FLAME CHECK FLAMEWIRING DIAGRAM IMPORTANT SAFEGUARDS CLEANINGTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED REPAIR PARTS SERVICINGPART DESCRIPTION REPLACEMENT PARTSKEY# PART NUMBERITTGENERAL CONTROLS PART DESCRIPTION REPLACEMENT PARTSKEY# PART NUMBER5 6 13 PagePILOT LIMITED WARRANTY MODEL FP-32 NEW BUCK CORPORATIONPage