New Buck Corporation 32 manual To Turn Off Gas To Appliance, Ignitor Electrode, Pilot Burner

Page 23

IGNITOR ELECTRODE

•If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.

IGNITOR ELECTRODE

THERMO--COUPLEPILE

PILOT BURNER

12.Turn control knob counterclockwise to the “ON” position. Push the “ON/OFF” toggle switch to the “ON” position. The main burner should light.

13.Close access panel door.

14.Turn on all electrical power to the appliance.

NOTE: This unit may be used with an optional Wall Thermostat. If so, the Wall Thermostat needs to be set at a higher temperature than the room temperature.

TO TURN OFF GAS TO

APPLIANCE

SHUTTING OFF UNIT

1.Open access panel door located at bottom front of the appliance.

2.“If equip with thermostat set to lowest setting.”

3.Turn control knob clockwise to the “OFF” position.

4.Turn off all electric power to the appliance if service is to be performed.

5.Close access panel door.

SHUTTING OFF BURNER ONLY (Pilot stays lit.)

Turn control knob clockwise		to the “PILOT” position.

Page 21

Image 23

Contents VENT-FREE MODELFREESTANDING FIREPLACE OR WITH AN OPTIONAL WOODEN SURROUNDPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa LEFT SIDE FigureCEILING WALL7.Place logs on the burner base as shown on page WALL FREESTANDING INSTALLATION MODEL 32 FSWALL WALL ALCOVE INSTALLATIONFOR YOUR SAFETY Installation” for minimum clearances INSTALLATION OF MODEL 32 WSWS ASSEMBLY INSTRUCTIONS WITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32NOTE: See “Producing Adequate Ventilation” page INSTALLATION IN RESIDENTIALOR AFTER-MARKETMOBILE HOMES DETERMINING FRESH-AIRFLOW FOR HEATER LOCATION PRODUCING ADEQUATE VENTILATIONVent-freeheater VENTILATION AIR FROM INSIDE BUILDING VENTILATION AIRVENTILATION AIR FROM OUTDOORS REAR LOG FRONT LOG PREPARING LOG KITTOP RIGHT TOP LEFTFLAME GAS CONNECTIONGAS PRESSURE CHECK WHAT TO DO IF YOU SMELL GAS FOR YOUR SAFETY, READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS MILLIVOLT VALVE ITT LIGHTING INSTRUCTIONS PILOT BURNER TO TURN OFF GAS TO APPLIANCEIGNITOR ELECTRODE THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDUREOR MANUAL VALVE SIT FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTION MODULATING VALVE SIT LIGHTING INSTRUCTION Page 12.Close access panel door13.Turn on all electrical power to the appliance 15seconds MANUAL LIGHTING PROCEDURETHERMOSTAT CONTROL OPERATION FLAME FLAME CHECKWIRING DIAGRAM CLEANING IMPORTANT SAFEGUARDSTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED SERVICING REPAIR PARTSPART NUMBER REPLACEMENT PARTSKEY# PART DESCRIPTIONITTGENERAL CONTROLS PART NUMBER REPLACEMENT PARTSKEY# PART DESCRIPTIONPILOT 5 6 13Page NEW BUCK CORPORATION LIMITED WARRANTY MODEL FP-32Page