New Buck Corporation 32 manual Lighting Instruction

Page 26
LIGHTING INSTRUCTION

LIGHTING INSTRUCTION

1.STOP! Read the safety information on preceding page 19.

2.Make sure manual shutoff valve is fully closed.

3.Turn off all electrical power to the appliance.

4.Open access panel door located at bottom front of the appliance.

5. Turn control knob clockwise

 

 

 

 

to the full “OFF” position.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” on preceding page in the Safety Information. If you don’t smell gas, go to the next step.

7.Find Pilot: The pilot is located in front of the rear log and burner on the right hand side of the appliance. Fully open the manual shutoff valve.

8. Press in and turn gas control knob counterclockwise

to the “PILOT” posi-

tion continue pressing in control knob for fifteen (15) seconds.

 

9.With control knob pressed in, push down (in) and release the ignitor button (ignitor button is located on the left hand side of the gas control valve) . This will light pilot. If needed, keep repeating this step until pilot lights.

10.Keep control knob pressed in for one (1) minute after lighting pilot. After one (1) minute,

release control knob and it will pop back up. Pilot should remain lit. If pilot goes out, repeat steps 1 through 9.

•If the knob does not pop up when released, stop and immediately call your service techni- cian or gas supplier.

•“If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your services technician or gas supplier.”

Page 24

Page 25 Page 27
Image 26
Page 25 Page 27
Contents OPTIONAL WOODEN SURROUND MODELFREESTANDING FIREPLACE OR WITH AN VENT-FREEPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa WALL FigureCEILING LEFT SIDE7.Place logs on the burner base as shown on page WALL FREESTANDING INSTALLATION MODEL 32 FSWALL WALL ALCOVE INSTALLATIONFOR YOUR SAFETY WITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32 INSTALLATION OF MODEL 32 WSWS ASSEMBLY INSTRUCTIONS Installation” for minimum clearancesNOTE: See “Producing Adequate Ventilation” page INSTALLATION IN RESIDENTIALOR AFTER-MARKETMOBILE HOMES PRODUCING ADEQUATE VENTILATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATIONVent-freeheater VENTILATION AIR VENTILATION AIR FROM INSIDE BUILDINGVENTILATION AIR FROM OUTDOORS TOP LEFT PREPARING LOG KITTOP RIGHT REAR LOG FRONT LOGGAS CONNECTION FLAMEGAS PRESSURE CHECK WHAT TO DO IF YOU SMELL GAS FOR YOUR SAFETY, READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS MILLIVOLT VALVE ITT LIGHTING INSTRUCTIONS PILOT BURNER TO TURN OFF GAS TO APPLIANCEIGNITOR ELECTRODE MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATIONOR MANUAL VALVE SIT FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTION MODULATING VALVE SIT LIGHTING INSTRUCTION Page 12.Close access panel door13.Turn on all electrical power to the appliance 15seconds MANUAL LIGHTING PROCEDURETHERMOSTAT CONTROL OPERATION FLAME CHECK FLAMEWIRING DIAGRAM IMPORTANT SAFEGUARDS CLEANINGTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED REPAIR PARTS SERVICINGPART DESCRIPTION REPLACEMENT PARTSKEY# PART NUMBERITTGENERAL CONTROLS PART DESCRIPTION REPLACEMENT PARTSKEY# PART NUMBERPILOT 5 6 13Page LIMITED WARRANTY MODEL FP-32 NEW BUCK CORPORATIONPage
Top Page Image Contents