New Buck Corporation 32 manual Place logs on the burner base as shown on page

Page 9

6.Slide the unit out and install the trim panels with a drill or screw gun. (Self tapping screws provided).

NOTE: Make sure the gas supply line is hooked up at this time, and check for leaks at the connection using soap and water.

7.Place logs on the burner base as shown on page 16.

8.For gas hookup and pressure tap test, see instructions on pages 17 & 18.

NOTE: When operated for the first time, the logs and paint may emit a “paper burning smell”. This smell will gradually diminish after a few hours of operation. Run the heater with the flue damper, windows or doors, open during this time. DO NOT use blower at this time.

Page 7

Image 9

Contents FREESTANDING FIREPLACE OR WITH AN MODELOPTIONAL WOODEN SURROUND VENT-FREEPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa CEILING FigureWALL LEFT SIDE7.Place logs on the burner base as shown on page FREESTANDING INSTALLATION MODEL 32 FS WALLWALL ALCOVE INSTALLATION FOR YOUR SAFETYWALL WS ASSEMBLY INSTRUCTIONS INSTALLATION OF MODEL 32 WSWITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32 Installation” for minimum clearancesINSTALLATION IN RESIDENTIAL OR AFTER-MARKETMOBILE HOMESNOTE: See “Producing Adequate Ventilation” page DETERMINING FRESH-AIRFLOW FOR HEATER LOCATION PRODUCING ADEQUATE VENTILATIONVent-freeheater VENTILATION AIR FROM INSIDE BUILDING VENTILATION AIRVENTILATION AIR FROM OUTDOORS TOP RIGHT PREPARING LOG KITTOP LEFT REAR LOG FRONT LOGFLAME GAS CONNECTIONGAS PRESSURE CHECK FOR YOUR SAFETY, READ BEFORE LIGHTING LIGHTING INSTRUCTIONS MILLIVOLT VALVE ITTWHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCE IGNITOR ELECTRODEPILOT BURNER THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDUREFOR YOUR SAFETY READ BEFORE LIGHTING LIGHTING INSTRUCTION MODULATING VALVE SITOR MANUAL VALVE SIT LIGHTING INSTRUCTION 12.Close access panel door 13.Turn on all electrical power to the appliancePage MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATION15seconds FLAME FLAME CHECKWIRING DIAGRAM CLEANING IMPORTANT SAFEGUARDSTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED SERVICING REPAIR PARTSKEY# REPLACEMENT PARTSPART DESCRIPTION PART NUMBERITTGENERAL CONTROLS KEY# REPLACEMENT PARTSPART DESCRIPTION PART NUMBER5 6 13 PagePILOT NEW BUCK CORPORATION LIMITED WARRANTY MODEL FP-32Page