New Buck Corporation 32 manual Thermostat Control Operation, Manual Lighting Procedure

Page 24

THERMOSTAT CONTROL OPERATION

THERMOSTAT CONTROL OPERATION

•This valve operates off of millivolts produced by the generator. You may choose to use an optional Wall Thermostat or Remote control. If so, see Figure 2, page 11 for wiring diagram.

MANUAL LIGHTING PROCEDURE

1.If the pilot cannot be lit with the piezo, it can be manually lit with the use of a paper match and a lighter rod.

2.Open access panel door located at bottom front of the appliance.

3.Place the match in the holder and light. With the left hand, turn the control knob

counterclockwise	to “PILOT”position. Press in gas control knob for fifteen (15)
seconds.

4.Use rod to light match and ignite pilot. The pilot is located in front of the rear log and burner on the right hand side of the appliance.

5.Continue to hold the control knob for an additional one (1) minute to ensure the pilot is lit.

6.	Turn control knob counterclockwise	to the “ON” position. Push the “ON/
	OFF” toggle switch to the “ON” position. The main burner should light.

7.Close access panel door.

8.Turn on all electrical power to the appliance.

NOTE: This unit may be used with an optional Wall Thermostat. If so, the Wall Thermostat needs to be set at a higher temperature than the room temperature.

Page 22

Image 24

Contents MODEL FREESTANDING FIREPLACE OR WITH ANOPTIONAL WOODEN SURROUND VENT-FREEPage TABLE OF CONTENTS Page SECTION SAFETY INFORMATION WARNINGS Do not try to light any appliance psi 3.5 kPa Figure CEILINGWALL LEFT SIDE7.Place logs on the burner base as shown on page FREESTANDING INSTALLATION MODEL 32 FS WALLWALL ALCOVE INSTALLATION FOR YOUR SAFETYWALL INSTALLATION OF MODEL 32 WS WS ASSEMBLY INSTRUCTIONSWITH OPTIONAL WOODEN SURROUNDKIT#PA-KDM32 Installation” for minimum clearancesINSTALLATION IN RESIDENTIAL OR AFTER-MARKETMOBILE HOMESNOTE: See “Producing Adequate Ventilation” page PRODUCING ADEQUATE VENTILATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATIONVent-freeheater VENTILATION AIR VENTILATION AIR FROM INSIDE BUILDINGVENTILATION AIR FROM OUTDOORS PREPARING LOG KIT TOP RIGHTTOP LEFT REAR LOG FRONT LOGGAS CONNECTION FLAMEGAS PRESSURE CHECK FOR YOUR SAFETY, READ BEFORE LIGHTING LIGHTING INSTRUCTIONS MILLIVOLT VALVE ITTWHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCE IGNITOR ELECTRODEPILOT BURNER MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATIONFOR YOUR SAFETY READ BEFORE LIGHTING LIGHTING INSTRUCTION MODULATING VALVE SITOR MANUAL VALVE SIT LIGHTING INSTRUCTION 12.Close access panel door 13.Turn on all electrical power to the appliancePage MANUAL LIGHTING PROCEDURE THERMOSTAT CONTROL OPERATION15seconds FLAME CHECK FLAMEWIRING DIAGRAM IMPORTANT SAFEGUARDS CLEANINGTROUBLE SHOOTING Air in gas lines when OBSERVED OBSERVED REPAIR PARTS SERVICINGREPLACEMENT PARTS KEY#PART DESCRIPTION PART NUMBERITTGENERAL CONTROLS REPLACEMENT PARTS KEY#PART DESCRIPTION PART NUMBER5 6 13 PagePILOT LIMITED WARRANTY MODEL FP-32 NEW BUCK CORPORATIONPage