LIGHTING INSTRUCTIONS
1.STOP! Read the safety information on previous page.
2.Make sure the manual shutoff valve is fully closed. If equipped with thermostat set to the lowest setting.
3.Turn off all electrical power to the appliance.
4.Open access panel door located at bottom front of the appliance.
5.Turn control knob clockwise 
to the full “OFF” position.
|
|
|
|
|
| ROCKER SWITCH |
|
| |
ITT VALVE | OFF | ON |
|
| |||||
PILOT ADJ | N |
|
| GEN THERMO |
|
| IGNITOR ELECTRODE | ||
P |
|
|
|
| |||||
T |
|
|
|
|
|
|
|
| |
O |
|
|
|
|
|
|
|
| |
IL | O |
|
|
|
|
|
|
| PILOT BURNER |
OFF |
| E | S | E | T | AUX | PIEZO |
| |
| TO |
|
|
| CONTROLS |
|
|
| |
| R |
|
|
|
|
|
| ||
PRESS |
|
|
|
| GENERALITT |
|
| THERMOPILE | |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| BURNER |
CONTROL KNOB |
|
|
|
|
| BEFORE INSTALLING THERMOSTAT |
| PILOT | |
|
|
|
|
| REMOVE METAL CONNECTOR |
|
| ||
|
|
|
|
|
|
|
|
| PILOT ASS'Y |
|
|
|
|
|
|
|
| 50 |
|
|
|
|
|
|
|
|
| 60 |
|
|
|
|
|
|
|
|
| 70 |
|
|
|
|
|
|
|
|
| 80 | FIGURE: 8 |
|
|
|
|
|
|
|
| 90 | |
|
|
|
|
|
|
| THERMOSTAT |
|
|
When hooking up a Wall Thermostat to valve, remove the Jumper Bar. Do not remove the existing wires, simply add the wire from the Wall Thermostat to screws (one wire to each screw).
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety informationon the previous page.If you don’t smell gas, go to the next step.
7.Find Pilot: The pilot is located in front of the rear log and burner on the right hand side of the appliance. Fully open the manual shutoff valve.
8.Push the ON/OFF toggle switch to “OFF” (rocker switch).
9. Turn gas control knob counterclockwise | to the “PILOT” position.Press in gas control |
knob for fifteen (15) seconds. |
|
10.With control knob pressed in , push down (in) and release the ignitor button (ignitor button is located on the left hand side of the front of the appliance). This will light the pilot. If needed, keep repeating this step until pilot lights.
11.Keep control knob pressed in for (1) one minute after lighting pilot. After (1) minute, release the gas control knob and it will pop back up. Pilot should remain lit. If pilot goes out, repeat steps 1 through 9.
•If the knob does not pop up when released, stop and immediately call your service technician or gas supplier.
Page 20